Hi Eduard, On Wed, Jun 13, 2001 at 12:46:52PM +0200, Eduard Bloch wrote: > Mehr Info bitte... AOpen AX59Pro BIOS 2.35 (das Neueste auf den AOpen-Servern) Realtek 8139 miroPCTV Dawicontrol SCSi-Controller 2674UW SB 64PCI > > Welcher Kernel? Hast du alle IRQs belegt? Ist "PNP-OS" im BIOS an- oder > deaktiviert? Schon mal im Bios die "DPMI" Daten reset'ed? die Meldungen tauchen so oder ähnlich bei allen Kernel ab 2.4.0 auf. Ich habe gerade 2.4.6-pre3 gebaut. Es hat sich nichts geändert. PNP-OS ist deaktiviert. Gerade habe ich die BIOS-Daten per Jumper auf dem Board gelöscht. Alles was ich nicht brauche ist im BIOS deaktiviert: USB, ACPI, Parallelport. Die Netzwerkkarte und die Graphikkarte teilen sich einen IRQ. Daran lässt sich scheinbar nichts ändern.
$ cat /proc/interrupts CPU0 0: 168452 XT-PIC timer 1: 9522 XT-PIC keyboard 2: 0 XT-PIC cascade 4: 2843 XT-PIC 5: 0 XT-PIC es1370 7: 53 XT-PIC sym53c8xx 8: 1 XT-PIC rtc 11: 11774 XT-PIC eth0 12: 72 XT-PIC bttv 14: 1932 XT-PIC ide0 15: 6 XT-PIC ide1 NMI: 0 ERR: 0 Was bedeuten die Meldungen überhaupt? Was macht die "pirq table"? Der PC läuft soweit relativ stabil. Allerdings stürzt er reproduzierbar ab, wenn ich fernsehe und dabei grössere Datenmengen über das Netzwerk kopiere. Das passiert auch mit 2.2er Kerneln und FreeBSD. Ich hänge mal den Output von dmesg an die Mail. Danke Michael
Linux version 2.4.6-pre3 ([EMAIL PROTECTED]) (gcc version 2.95.2 20000220 (Debian GNU/Linux)) #1 Mit Jun 13 14:30:52 MEST 2001 BIOS-provided physical RAM map: BIOS-e820: 0000000000000000 - 00000000000a0000 (usable) BIOS-e820: 00000000000f0000 - 0000000000100000 (reserved) BIOS-e820: 0000000000100000 - 0000000008000000 (usable) BIOS-e820: 00000000ffff0000 - 0000000100000000 (reserved) On node 0 totalpages: 32768 zone(0): 4096 pages. zone(1): 28672 pages. zone(2): 0 pages. Kernel command line: BOOT_IMAGE=Lin ro root=302 BOOT_FILE=/boot/bzImage-2.4.6-pre3 Initializing CPU#0 Detected 400.923 MHz processor. Console: colour dummy device 80x25 Calibrating delay loop... 799.53 BogoMIPS Memory: 126572k/131072k available (1061k kernel code, 4116k reserved, 410k data, 224k init, 0k highmem) Dentry-cache hash table entries: 16384 (order: 5, 131072 bytes) Inode-cache hash table entries: 8192 (order: 4, 65536 bytes) Mount-cache hash table entries: 2048 (order: 2, 16384 bytes) Buffer-cache hash table entries: 8192 (order: 3, 32768 bytes) Page-cache hash table entries: 32768 (order: 5, 131072 bytes) CPU: Before vendor init, caps: 008021bf 808029bf 00000000, vendor = 2 CPU: L1 I Cache: 32K (32 bytes/line), D cache 32K (32 bytes/line) CPU: After vendor init, caps: 008021bf 808029bf 00000000 00000002 CPU: After generic, caps: 008021bf 808029bf 00000000 00000002 CPU: Common caps: 008021bf 808029bf 00000000 00000002 CPU: AMD-K6(tm) 3D processor stepping 0c Checking 'hlt' instruction... OK. POSIX conformance testing by UNIFIX mtrr: v1.40 (20010327) Richard Gooch ([EMAIL PROTECTED]) mtrr: detected mtrr type: AMD K6 PCI: PCI BIOS revision 2.10 entry at 0xfb4e0, last bus=1 PCI: Using configuration type 1 PCI: Probing PCI hardware PCI: Disabled enhanced CPU to PCI posting #2 Unknown bridge resource 0: assuming transparent PCI: Using IRQ router VIA [1106/0586] at 00:07.0 Activating ISA DMA hang workarounds. isapnp: Scanning for PnP cards... isapnp: No Plug & Play device found Linux NET4.0 for Linux 2.4 Based upon Swansea University Computer Society NET3.039 apm: BIOS version 1.2 Flags 0x07 (Driver version 1.14) Starting kswapd v1.8 vesafb: framebuffer at 0xe6000000, mapped to 0xc8800000, size 16320k vesafb: mode is 800x600x16, linelength=1600, pages=16 vesafb: protected mode interface info at c000:02e9 vesafb: scrolling: redraw vesafb: directcolor: size=0:5:6:5, shift=0:11:5:0 Console: switching to colour frame buffer device 100x37 fb0: VESA VGA frame buffer device pty: 256 Unix98 ptys configured Serial driver version 5.05a (2001-03-20) with MANY_PORTS SHARE_IRQ SERIAL_PCI ISAPNP enabled ttyS00 at 0x03f8 (irq = 4) is a 16550A ttyS01 at 0x02f8 (irq = 3) is a 16550A Real Time Clock Driver v1.10d block: queued sectors max/low 84000kB/28000kB, 256 slots per queue Uniform Multi-Platform E-IDE driver Revision: 6.31 ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx VP_IDE: IDE controller on PCI bus 00 dev 39 VP_IDE: chipset revision 6 VP_IDE: not 100% native mode: will probe irqs later ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx VP_IDE: VIA vt82c586b (rev 47) IDE UDMA33 controller on pci00:07.1 ide0: BM-DMA at 0x6400-0x6407, BIOS settings: hda:DMA, hdb:pio ide1: BM-DMA at 0x6408-0x640f, BIOS settings: hdc:DMA, hdd:pio hda: IBM-DHEA-36480, ATA DISK drive hdc: IBM-DJNA-351520, ATA DISK drive ide0 at 0x1f0-0x1f7,0x3f6 on irq 14 ide1 at 0x170-0x177,0x376 on irq 15 hda: 12692736 sectors (6499 MB) w/476KiB Cache, CHS=790/255/63, UDMA(33) hdc: 30033360 sectors (15377 MB) w/430KiB Cache, CHS=29795/16/63, UDMA(33) Partition check: hda: hda1 hda2 hda3 < hda5 hda6 hda7 hda8 > hda1: <bsd: hda9 hda10 hda11 hda12 > hdc: [PTBL] [1869/255/63] hdc1 Floppy drive(s): fd0 is 1.44M FDC 0 is a post-1991 82077 Linux agpgart interface v0.99 (c) Jeff Hartmann agpgart: Maximum main memory to use for agp memory: 96M agpgart: Detected Via MVP3 chipset agpgart: AGP aperture is 64M @ 0xe0000000 SCSI subsystem driver Revision: 1.00 PCI: Found IRQ 5 for device 00:09.0 IRQ routing conflict in pirq table for device 00:09.0 sym53c8xx: at PCI bus 0, device 9, function 0 sym53c8xx: setting PCI_COMMAND_PARITY...(fix-up) sym53c8xx: 53c875 detected sym53c875-0: rev 0x26 on pci bus 0 device 9 function 0 irq 7 sym53c875-0: ID 7, Fast-20, Parity Checking scsi0 : sym53c8xx-1.7.3a-20010304 Vendor: PLEXTOR Model: CD-ROM PX-40TS Rev: 1.03 Type: CD-ROM ANSI SCSI revision: 02 Vendor: SCSI-CD Model: ReWritable-2x2x6 Rev: 2.00 Type: CD-ROM ANSI SCSI revision: 02 Detected scsi CD-ROM sr0 at scsi0, channel 0, id 3, lun 0 Detected scsi CD-ROM sr1 at scsi0, channel 0, id 4, lun 0 sym53c875-0-<3,*>: FAST-20 SCSI 20.0 MB/s (50.0 ns, offset 15) sr0: scsi-1 drive Uniform CD-ROM driver Revision: 3.12 sym53c875-0-<4,*>: FAST-10 SCSI 10.0 MB/s (100.0 ns, offset 15) sr1: scsi3-mmc drive: 6x/6x writer cd/rw xa/form2 cdda tray NET4: Linux TCP/IP 1.0 for NET4.0 IP Protocols: ICMP, UDP, TCP, IGMP IP: routing cache hash table of 1024 buckets, 8Kbytes TCP: Hash tables configured (established 8192 bind 8192) NET4: Unix domain sockets 1.0/SMP for Linux NET4.0. VFS: Mounted root (ext2 filesystem) readonly. Freeing unused kernel memory: 224k freed Adding Swap: 192740k swap-space (priority -1) 8139too Fast Ethernet driver 0.9.17 PCI: Found IRQ 7 for device 00:0c.0 IRQ routing conflict in pirq table for device 00:0c.0 eth0: RealTek RTL8139 Fast Ethernet at 0xc9828000, 00:40:95:33:85:2b, IRQ 11 eth0: Identified 8139 chip type 'RTL-8139B' es1370: version v0.37 time 14:42:34 Jun 13 2001 PCI: Found IRQ 11 for device 00:0a.0 IRQ routing conflict in pirq table for device 00:0a.0 es1370: found adapter at io 0x7000 irq 5 es1370: features: joystick off, line in, mic impedance 0 eth0: Setting 100mbps full-duplex based on auto-negotiated partner ability 41e1. lp: driver loaded but no devices found Linux video capture interface: v1.00 i2c-core.o: i2c core module i2c-algo-bit.o: i2c bit algorithm module bttv: driver version 0.7.57 loaded bttv: using 2 buffers with 2080k (4160k total) for capture bttv: Bt8xx card found (0). PCI: Found IRQ 12 for device 00:0b.0 bttv0: Bt848 (rev 18) at 00:0b.0, irq: 12, latency: 32, memory: 0xe8002000 bttv0: model: BT848A(MIRO PCTV) [insmod option] i2c-algo-bit.o: Adapter: bt848 #0 scl: 1 sda: 1 -- testing... i2c-algo-bit.o:1 scl: 1 sda: 0 i2c-algo-bit.o:2 scl: 1 sda: 1 i2c-algo-bit.o:3 scl: 0 sda: 1 i2c-algo-bit.o:4 scl: 1 sda: 1 i2c-algo-bit.o: bt848 #0 passed test. i2c-core.o: adapter bt848 #0 registered as adapter 0. bttv0: i2c: checking for MSP34xx @ 0x80... not found bttv0: miro: id=1 tuner=0 radio=no stereo=no bttv0: i2c: checking for MSP34xx @ 0x80... not found bttv0: i2c: checking for TDA9875 @ 0xb0... not found bttv0: i2c: checking for TDA7432 @ 0x8a... not found tvaudio: TV audio decoder + audio/video mux driver tvaudio: known chips: tda9840,tda9873h,tda9850,tda9855,tea6300,tea6420,tda8425,pic16c54 (PV951) i2c-core.o: driver generic i2c audio driver registered. i2c-core.o: driver i2c TV tuner driver registered. tuner: chip found @ 0x60 bttv0: i2c attach [Temic PAL (4002 FH5)] i2c-core.o: client [Temic PAL (4002 FH5)] registered to adapter [bt848 #0](pos. 0).