Bonjour, Je rencontre un petit soucis pour utiliser NFS. J'utilise une debian testing avec un kernel Linux 2.4.20 mips (dmesg plus bas). Nfs, portmap, mountd lockd, etc. se lancent au démarrage. <[EMAIL PROTECTED]>~ % rpcinfo -p program vers proto port 100000 2 tcp 111 portmapper 100000 2 udp 111 portmapper 100003 2 udp 2049 nfs 100003 3 udp 2049 nfs 100021 1 udp 1024 nlockmgr 100021 3 udp 1024 nlockmgr 100021 4 udp 1024 nlockmgr 100005 1 udp 672 mountd 100005 1 tcp 675 mountd 100005 2 udp 672 mountd 100005 2 tcp 675 mountd 100005 3 udp 672 mountd 100005 3 tcp 675 mountd 100024 1 udp 725 status 100024 1 tcp 728 status <[EMAIL PROTECTED]>~ % sudo showmount -e Export list for nirvana: /home/ericd *.workgroup J'arrive à monter le share correctement depuis un client ou depuis le serveur lui-même: <[EMAIL PROTECTED]>~ % mount /dev/hda1 on / type ext3 (rw,noatime,errors=remount-ro) proc on /proc type proc (rw) usbfs on /proc/bus/usb type usbfs (rw) devpts on /dev/pts type devpts (rw,gid=5,mode=620) /dev/hda3 on /mnt/hda type ext3 (rw,noatime) nirvana:/home/ericd on /mnt/usbdisk1 type nfs (rw,addr=192.168.1.250)
Mais ni le client ni le serveur n'arrive à lire ou ecrire sur le share. Les commandes restent figées en statut D (in disk). 699 ? D 0:00 ls -la --color=auto /mnt/usbdisk1 De temps en temps il affiche nfs server not responding, alors que le serveur lui-même n'a pas perdu la connectivité au réseau. Je ne sais pas comment résoudre ca. Cordialement, Eric Dillenseger dmesg: prom.c:RAM_FIRST 400 _ftext 100000 _end 52dc40 CPU revision is: 0001800a Primary instruction cache 8kB, physically tagged, 4-way, linesize 16 bytes. Primary data cache 8kB 4-way, linesize 16 bytes. Linux version 2.4.20_mipsel_linkstation ([EMAIL PROTECTED]) (gcc ¥Ð¡¼¥¸¥ç¥ó 3.3.1 (MontaVista 3.3.1-3.0.10.0300532 2003-12-24)) #88 2005ǯ 2·î 25Æü ¶âÍËÆü 20:17:00 JST PCI: Initializing PCI Determined physical RAM map: memory: 04000000 @ 00000000 (usable) Initial ramdisk at: 0x802d6000 (2306048 bytes) On node 0 totalpages: 16384 zone(0): 16384 pages. zone(1): 0 pages. zone(2): 0 pages. Kernel command line: root=/dev/hda1 Initializing IRQ's: 168 out of 256 Rx5C348: driver initialized calculating r4koff... 001e83b7(1999799) CPU frequency 399.96 MHz Calibrating delay loop... 399.76 BogoMIPS MIPS CPU counter frequency is fixed at 199979981 Hz Memory: 59516k/65536k available (1593k kernel code, 6020k reserved, 2436k data, 76k init, 0k highmem) Dentry cache hash table entries: 8192 (order: 4, 65536 bytes) Inode cache hash table entries: 4096 (order: 3, 32768 bytes) Mount-cache hash table entries: 1024 (order: 1, 8192 bytes) Buffer-cache hash table entries: 4096 (order: 2, 16384 bytes) Page-cache hash table entries: 16384 (order: 4, 65536 bytes) Checking for 'wait' instruction... available. POSIX conformance testing by UNIFIX 00:02.0 : 1283:8212 00:04.0 : 1033:0035 00:04.1 : 1033:0035 00:04.2 : 1033:00e0 Linux NET4.0 for Linux 2.4 Based upon Swansea University Computer Society NET3.039 Initializing RT netlink socket LSP Revision 10 Starting kswapd Disabling the Out Of Memory Killer Journalled Block Device driver loaded pty: 256 Unix98 ptys configured Serial driver version 5.05c (2001-07-08) with MANY_PORTS SHARE_IRQ SERIAL_PCI enabled ttyS00 at 0xb8058000 (irq = 104) is a 16550A Generic MIPS RTC Driver v1.0 Uniform Multi-Platform E-IDE driver Revision: 6.31 ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx IT8212: IDE controller on PCI bus 00 dev 10 IT8212: chipset revision 19 IT8212: 100% native mode on irq 146 ide0: BM-DMA at 0x18800020-0x18800027, BIOS settings: hda:pio, hdb:pio ide1: BM-DMA at 0x18800028-0x1880002f, BIOS settings: hdc:pio, hdd:pio hda: ST3250823A, ATA DISK drive ide0 at 0x18800000-0x18800007,0x1880000a on irq 146 blk: queue 8052b628, I/O limit 4095Mb (mask 0xffffffff) hda: 488397168 sectors (250059 MB) w/8192KiB Cache, CHS=30401/255/63, UDMA(100) Partition check: hda: hda1 hda2 hda3 RAMDISK driver initialized: 16 RAM disks of 10000K size 1024 blocksize eth0: RC32434 ethernet found at 0x18060000 eth0: HW Address 00:0d:0b:74:5f:3d eth0: Rx IRQ 40, Tx IRQ 41 SCSI subsystem driver Revision: 1.00 kmod: failed to exec /sbin/modprobe -s -k scsi_hostadapter, errno = 2 physmap flash device: 400000 at 1fc00000 Found: ST M29W324DB linkstation_flash: Found 1 x16 devices at 0x0 in 8-bit mode number of JEDEC chips: 1 Using physmap partition definition Creating 3 MTD partitions on "linkstation_flash": 0x00000000-0x00040000 : "mtd0" 0x00040000-0x00390000 : "mtd1" 0x003c0000-0x00400000 : "mtd2" usb.c: registered new driver usbdevfs usb.c: registered new driver hub ehci_hcd 00:04.2: PCI device 1033:00e0 ehci_hcd 00:04.2: irq 148, pci mem c0000000 usb.c: new USB bus registered, assigned bus number 1 PCI: 00:04.2 PCI cache line size set incorrectly (0 bytes) by BIOS/FW, correcting to 32 ehci_hcd 00:04.2: USB 2.0 enabled, EHCI 1.00, driver 2003-Dec-29/2.4 hub.c: USB hub found hub.c: 5 ports detected usb-ohci.c: USB OHCI at membase 0xc0002000, IRQ 148 usb-ohci.c: usb-00:04.0, PCI device 1033:0035 usb.c: new USB bus registered, assigned bus number 2 hub.c: USB hub found hub.c: 3 ports detected usb-ohci.c: USB OHCI at membase 0xc0004000, IRQ 148 usb-ohci.c: usb-00:04.1, PCI device 1033:0035 usb.c: new USB bus registered, assigned bus number 3 hub.c: USB hub found hub.c: 2 ports detected usb.c: registered new driver usblp printer.c: v0.13: USB Printer Device Class driver Initializing USB Mass Storage driver... usb.c: registered new driver usb-storage USB Mass Storage support registered. NET4: Linux TCP/IP 1.0 for NET4.0 IP Protocols: ICMP, UDP, TCP, IGMP IP: routing cache hash table of 512 buckets, 4Kbytes TCP: Hash tables configured (established 4096 bind 8192) NET4: Unix domain sockets 1.0/SMP for Linux NET4.0. NET4: AppleTalk 0.18a for Linux NET4.0 RAMDISK: Compressed image found at block 0 hub.c: new USB device 00:04.2-2, assigned address 2 scsi0 : SCSI emulation for USB Mass Storage devices Vendor: ST320082 Model: 2A Rev: 0 0 Type: Direct-Access RMB: HardDisk ANSI SCSI revision: 02 Attached scsi disk sda at scsi0, channel 0, id 0, lun 0 SCSI device sda: 390721968 512-byte hdwr sectors (200050 MB) sda: sda1 WARNING: USB Mass Storage data integrity not assured USB Mass Storage device found at 2 Freeing initrd memory: 2252k freed EXT2-fs warning: checktime reached, running e2fsck is recommended VFS: Mounted root (ext2 filesystem). kjournald starting. Commit interval 5 seconds EXT3-fs: mounted filesystem with ordered data mode. VFS: Mounted root (ext3 filesystem) readonly. Trying to move old root to /initrd ... okay stubbed prom_free_prom_memory() Freeing unused kernel memory: 76k freed Warning: unable to open an initial console. Algorithmics/MIPS FPU Emulator v1.5 Adding Swap: 265064k swap-space (priority -1) EXT3 FS 2.4-0.9.19, 19 August 2002 on ide0(3,1), internal journal kjournald starting. Commit interval 5 seconds EXT3-fs warning: maximal mount count reached, running e2fsck is recommended EXT3 FS 2.4-0.9.19, 19 August 2002 on ide0(3,3), internal journal EXT3-fs: mounted filesystem with ordered data mode. Installing knfsd (copyright (C) 1996 [EMAIL PROTECTED]). -- "Any attempt to brew coffee with a teapot should result in the error code "418 I'm a teapot". The resulting entity body MAY be short and stout." -- HTCPCP Spec, RFC 2324