Hallo, Ich habe ein Probelm mit einer nachträglich eingebauten Promise Ultra100TX2. Die Karte wird zwar erkannt, die an ihr angeschlossene Platte aber nicht. Auch fdisk /dev/hde sagt "Unable to open /dev/hde" Allerdings hat ein älteres Knoppix damit überhaupt keine Probleme.
Wie kann ich den Kernel bzw. seine Module konfigurieren, dass beim Booten auch die Hardware am Ultra100 erkannt wird? Oder funkt mir da etwas anderes dazwischen? ACPI oder so? Danke, Robert Ausgabe von dmesg Linux version 2.6.8-2-686 ([EMAIL PROTECTED]) (gcc version 3.3.5 (Debian 1:3.3.5-6)) #1 Mon Jan 24 03:58:38 EST 2005 BIOS-provided physical RAM map: BIOS-e820: 0000000000000000 - 000000000009e800 (usable) BIOS-e820: 000000000009e800 - 00000000000a0000 (reserved) BIOS-e820: 00000000000f0000 - 0000000000100000 (reserved) BIOS-e820: 0000000000100000 - 0000000007ffd000 (usable) BIOS-e820: 0000000007ffd000 - 0000000007fff000 (ACPI data) BIOS-e820: 0000000007fff000 - 0000000008000000 (ACPI NVS) BIOS-e820: 00000000ffff0000 - 0000000100000000 (reserved) 0MB HIGHMEM available. 127MB LOWMEM available. On node 0 totalpages: 32765 DMA zone: 4096 pages, LIFO batch:1 Normal zone: 28669 pages, LIFO batch:6 HighMem zone: 0 pages, LIFO batch:1 DMI 2.0 present. ACPI disabled because your bios is from 98 and too old You can enable it with acpi=force Built 1 zonelists Kernel command line: root=/dev/sda6 ro Local APIC disabled by BIOS -- reenabling. Found and enabled local APIC! Initializing CPU#0 PID hash table entries: 512 (order 9: 4096 bytes) Detected 350.846 MHz processor. Using tsc for high-res timesource Console: colour VGA+ 80x25 Dentry cache hash table entries: 32768 (order: 5, 131072 bytes) Inode-cache hash table entries: 16384 (order: 4, 65536 bytes) Memory: 121984k/131060k available (1550k kernel code, 8528k reserved, 688k data, 148k init, 0k highmem) Checking if this processor honours the WP bit even in supervisor mode... Ok. Calibrating delay loop... 690.17 BogoMIPS Security Scaffold v1.0.0 initialized Mount-cache hash table entries: 512 (order: 0, 4096 bytes) CPU: After generic identify, caps: 0183fbff 00000000 00000000 00000000 CPU: After vendor identify, caps: 0183fbff 00000000 00000000 00000000 CPU: L1 I cache: 16K, L1 D cache: 16K CPU: L2 cache: 512K CPU: After all inits, caps: 0183fbff 00000000 00000000 00000040 Intel machine check architecture supported. Intel machine check reporting enabled on CPU#0. CPU: Intel Pentium II (Deschutes) stepping 02 Enabling fast FPU save and restore... done. Checking 'hlt' instruction... OK. enabled ExtINT on CPU#0 ESR value before enabling vector: 00000000 ESR value after enabling vector: 00000000 Using local APIC timer interrupts. calibrating APIC timer ... ..... CPU clock speed is 350.0739 MHz. ..... host bus clock speed is 100.0211 MHz. checking if image is initramfs...it isn't (ungzip failed); looks like an initrd Freeing initrd memory: 4672k freed NET: Registered protocol family 16 PCI: PCI BIOS revision 2.10 entry at 0xf0750, last bus=1 PCI: Using configuration type 1 mtrr: v2.0 (20020519) ACPI: Subsystem revision 20040326 ACPI: Interpreter disabled. Linux Plug and Play Support v0.97 (c) Adam Belay PnPBIOS: Scanning system for PnP BIOS support... PnPBIOS: Found PnP BIOS installation structure at 0xc00fd110 PnPBIOS: PnP BIOS version 1.0, entry 0xf0000:0xd140, dseg 0xf0000 pnp: 00:0f: ioport range 0x290-0x297 has been reserved pnp: 00:0f: ioport range 0xe400-0xe43f has been reserved pnp: 00:0f: ioport range 0xe800-0xe83f has been reserved PnPBIOS: 15 nodes reported by PnP BIOS; 15 recorded by driver PCI: Probing PCI hardware PCI: Probing PCI hardware (bus 00) PCI: Using IRQ router PIIX/ICH [8086/7110] at 0000:00:04.0 PCI: IRQ 0 for device 0000:00:04.2 doesn't match PIRQ mask - try pci=usepirqmask PCI: Found IRQ 5 for device 0000:00:04.2 PCI: Sharing IRQ 5 with 0000:00:06.0 VFS: Disk quotas dquot_6.5.1 Dquot-cache hash table entries: 1024 (order 0, 4096 bytes) devfs: 2004-01-31 Richard Gooch ([EMAIL PROTECTED]) devfs: boot_options: 0x0 Initializing Cryptographic API Limiting direct PCI/PCI transfers. isapnp: Scanning for PnP cards... isapnp: No Plug & Play device found Serial: 8250/16550 driver $Revision: 1.90 $ 48 ports, IRQ sharing enabled ttyS0 at I/O 0x3f8 (irq = 4) is a 16550A ttyS1 at I/O 0x2f8 (irq = 3) is a 16550A RAMDISK driver initialized: 16 RAM disks of 8192K size 1024 blocksize serio: i8042 AUX port at 0x60,0x64 irq 12 serio: i8042 KBD port at 0x60,0x64 irq 1 input: AT Translated Set 2 keyboard on isa0060/serio0 NET: Registered protocol family 2 IP: routing cache hash table of 512 buckets, 4Kbytes TCP: Hash tables configured (established 8192 bind 16384) NET: Registered protocol family 8 NET: Registered protocol family 20 RAMDISK: cramfs filesystem found at block 0 RAMDISK: Loading 4672 blocks [1 disk] into ram disk... done. VFS: Mounted root (cramfs filesystem) readonly. Freeing unused kernel memory: 148k freed vesafb: probe of vesafb0 failed with error -6 NET: Registered protocol family 1 SCSI subsystem initialized PCI: Found IRQ 5 for device 0000:00:06.0 PCI: Sharing IRQ 5 with 0000:00:04.2 scsi0 : Adaptec AIC7XXX EISA/VLB/PCI SCSI HBA DRIVER, Rev 6.2.36 <Adaptec aic7890/91 Ultra2 SCSI adapter> aic7890/91: Ultra2 Wide Channel A, SCSI Id=7, 32/253 SCBs Using anticipatory io scheduler (scsi0:A:0): 80.000MB/s transfers (40.000MHz, offset 15, 16bit) Vendor: IBM Model: DDRS-39130D Rev: DC1B Type: Direct-Access ANSI SCSI revision: 02 scsi0:A:0:0: Tagged Queuing enabled. Depth 8 SCSI device sda: 17850000 512-byte hdwr sectors (9139 MB) SCSI device sda: drive cache: write back /dev/scsi/host0/bus0/target0/lun0: p2 < p5 p6 p7 p8 > Attached scsi disk sda at scsi0, channel 0, id 0, lun 0 kjournald starting. Commit interval 5 seconds EXT3-fs: mounted filesystem with ordered data mode. Adding 377488k swap on /dev/sda5. Priority:-1 extents:1 EXT3 FS on sda6, internal journal Real Time Clock Driver v1.12 Uniform Multi-Platform E-IDE driver Revision: 7.00alpha2 ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx input: ImExPS/2 Generic Explorer Mouse on isa0060/serio1 Capability LSM initialized mice: PS/2 mouse device common for all mice ts: Compaq touchscreen protocol output kjournald starting. Commit interval 5 seconds EXT3 FS on sda8, internal journal EXT3-fs: mounted filesystem with ordered data mode. kjournald starting. Commit interval 5 seconds EXT3 FS on sda7, internal journal EXT3-fs: mounted filesystem with ordered data mode. Linux agpgart interface v0.100 (c) Dave Jones dmfe: Davicom DM9xxx net driver, version 1.36.4 (2002-01-17) PCI: Found IRQ 11 for device 0000:00:0c.0 eth0: Davicom DM9102 at pci0000:00:0c.0, 00:08:a1:2c:76:fb, irq 11. usbcore: registered new driver usbfs usbcore: registered new driver hub USB Universal Host Controller Interface driver v2.2 PCI: Found IRQ 5 for device 0000:00:04.2 PCI: Sharing IRQ 5 with 0000:00:06.0 uhci_hcd 0000:00:04.2: Intel Corp. 82371AB/EB/MB PIIX4 USB uhci_hcd 0000:00:04.2: irq 5, io base 0000d400 uhci_hcd 0000:00:04.2: new USB bus registered, assigned bus number 1 hub 1-0:1.0: USB hub found hub 1-0:1.0: 2 ports detected parport: PnPBIOS parport detected. parport0: PC-style at 0x378 (0x778), irq 7, dma 3 [PCSPP,TRISTATE,COMPAT,EPP,ECP,DMA] inserting floppy driver for 2.6.8-2-686 Floppy drive(s): fd0 is 1.44M FDC 0 is a post-1991 82077 input: PC Speaker agpgart: Detected an Intel 440BX Chipset. agpgart: Maximum main memory to use for agp memory: 94M agpgart: AGP aperture is 64M @ 0xe4000000 cpci_hotplug: CompactPCI Hot Plug Core version: 0.2 pci_hotplug: PCI Hot Plug PCI Core version: 0.5 pciehp: acpi_pciehprm:get_device PCI ROOT HID fail=0x1001 shpchp: acpi_shpchprm:get_device PCI ROOT HID fail=0x1001 Linux Tulip driver version 1.1.13 (May 11, 2002) NET: Registered protocol family 17 NET: Registered protocol family 10 Disabled Privacy Extensions on device c02ff020(lo) IPv6 over IPv4 tunneling driver eth0: no IPv6 routers present -- Haeufig gestellte Fragen und Antworten (FAQ): http://www.de.debian.org/debian-user-german-FAQ/ Zum AUSTRAGEN schicken Sie eine Mail an [EMAIL PROTECTED] mit dem Subject "unsubscribe". Probleme? Mail an [EMAIL PROTECTED] (engl)