hola gente, tengo instalado una debian sarge con el kernel que trae por defecto 2.6.7.1 donde me funcionaba una camara usb que monto asi:
mount /dev/sda /mnt/camara -t vfat al conectarla me soltaba esto: usb 2-1: new full speed USB device using address 2 Initializing USB Mass Storage driver... scsi0 : SCSI emulation for USB Mass Storage devices Vendor: HP Model: PhotoSmart 43x Rev: No.1 Type: Direct-Access ANSI SCSI revision: 02 Attached scsi generic sg0 at scsi0, channel 0, id 0, lun 0, type 0 USB Mass Storage device found at 2 usbcore: registered new driver usb-storage USB Mass Storage support registered. SCSI device sda: 121818 512-byte hdwr sectors (62 MB) sda: assuming Write Enabled sda: assuming drive cache: write through /dev/scsi/host0/bus0/target0/lun0: unknown partition table Attached scsi removable disk sda at scsi0, channel 0, id 0, lun 0 ahora me paso a un kernel 2.6.12.1 y he probado miles de configuraciones de modulos pero siempre me suelta esto y no monta la camara: ohci_hcd 0000:00:02.1: wakeup usb 2-2: new full speed USB device using ohci_hcd and address 2 ub(2.2): GetMaxLUN returned 0 bytes ub(2.2): GetMaxLUN returned 0 bytes Initializing USB Mass Storage driver... ub(2.2): GetMaxLUN returned 0 bytes /dev/ub/a: unknown partition table usbcore: registered new driver usb-storage USB Mass Storage support registered. sabeis que puede ser? me estoy volviendo loco de tanto reiniciar, he puesto los mismos modulos que el kernel 2.6.7 (creo) y ni aun asi... no me lo explico gracias