Jerome BENOIT wrote:
Hello,
the package initrd-tools was recently updated [and if I remember well important bugs were fixed]:
have you check that your kernel was built with the latest version ?
hth, Jerome
Steven Curtis wrote:
Stefan O'Rear wrote:
On Fri, Sep 10, 2004 at 07:58:53PM -0400, Steven Curtis wrote:As to the first question, by examining the /tmp directory left by using the -k switch on mkinitrd, I can verify that /initrd/loadmodules contains the line 'modprobe -k aic7xxx' and that /initrd/lib/modules/2.6.7-1-k7/kernel/drivers/scsi/aic7xxx/aic7xxx.ko exists. I cannot verify these things on the image itself because I need to load loop support to mount the initrd image and when I modprobe loop, its missing the symbols kunmap_high, create_bounce, highmem_start_page, and kmap_high.
I'm trying to upgrade to the vmlinuz-2.6.7-1-k7 kernel and my system has an Adaptec AIC7XXX EISA/VLB/PCI adapter. The stock vmlinuz-2.6.7-1-k7 kernel has aic7xxx support compiled as a module. I added the aic7xxx module line to /etc/mkinitrd/modules and recreated the initrd image with 'mkinitrd -o /boot/initrd.img-2.6.7-1-k7 2.6.7-1-k7'. I'm using grub as my boot loader so I figured all is well. Booting the new kernel does not load the module and thus upon trying to mount the root file system produces the following:
VFS:cannot open root device "sda2"or unknown-block (0,0) Please append correct "root=" boot option Kernel panic: VFS Unable to mount root fs on unknown-block(0,0)
presumably because the SCSI module has not been loaded yet. I do not see any of the probing messages my old 2.4.19 kernel outputs which has aic7xxx support compiled in. Any advice or suggestions on where to look for problems or what I have done wrong?
Is the actual module (.ko file) in /etc/mkinitrd? Does the kernel give a message when loading the module?
As to the second question, I know that the SCSI card is not being probed because when it is probed, the devices take their time when responding. After the Kernel panic, I am unable to scroll back up to see what messages may have been output before that point. From what is visible on the screen, there are no messages of any modules getting loaded. The only mention of a ramdisk is a line that reads: 'RAMDISK driver initialized: 16 RAM disks of 8192K size 1024 blocksize'. The last screen visible before the panic starts with 'devfs: boot_options: 0x0'. I've read that devfs can cause problems, but the same behavior is observed with the 'devfs=nomount' boot parameter.
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]