On Tue, Nov 16, 2004 at 01:47:06PM -0500, Kaplan, Andrew H. wrote: > Hi there -- > > I am experimenting with Debian 3.0r1 and have a Visualize C3700 workstation.
I guess [EMAIL PROTECTED] might be more helpful than debian-user for this. Frank > I have downloaded the > HPPA images and have gone through the motions of installing the operating > system. What happens > is the following: > > I insert the CD into the system and interrupt the boot process. I then run a > SEArch on the system > for the appropriate drives. The CD-ROM and hard drive (located in FWSCSI.6.0) > are detected. I then > type in BO P0, P0 being the 'path' for the CD-ROM drive, to boot from the CD. > The system appears > to begin the install process but then the screen goes black. After a minute > what > appears to be a > screen dump of some kind appears onscreen. There is no further action that > takes > place, and the > only recourse I have is to reboot the system. > > I have also simply inserted the CD and booted up the system, with the results > being the same as > those listed above. > > Has anyone seen this problem and been able to overcome it? Thanks. > > > -- > To UNSUBSCRIBE, email to [EMAIL PROTECTED] > with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED] -- "Debugging is twice as hard as writing the code in the first place. Therefore, if you write the code as cleverly as possible, you are, by definition, not smart enough to debug it." - Brian W. Kernighan -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
