Please excuse me if I am wrong in my assumption that this is the correct place to ask a question such as the following...
I am really in a bind here. After an agonizing week of waiting, my new debian CD showed up and I got to work installing. Everything went smoothly untill I went to install the kernel modules. I have a 'reveal' cd rom drive (possibly made by panasonic), that connects to the SC400 Reveal 4R sound card. I tried to install the sbpcd module for the kernel during the install, but after taking 5 minutes or so to test a variety of addresses and names (SoundBlaster, Lasersomethingorother, etc), it said that the installation failed. It seemed to get something at 0x230 SoundBlaster (the busy light on the drive went on) but after spending a bit of time there, it just continues. I took those parameters and tried to feed them in manually doing: append "sbpcd=0x230,SoundBlaster" but it doesnt do anything. I read the CDROM howto, and that was the only advice I could glean from it. As you may have gathered, I am really at a loss here, and would be most grateful for any help offered. Ciao, David Welton [EMAIL PROTECTED] [EMAIL PROTECTED] http://www.efn.org/~davidw Se quest'email e` in Italiano, mi dispiace per gli errori:-) FORZA PANTANI! -- This message was distributed manually by [EMAIL PROTECTED] after the list initially failed to distribute it.