-----BEGIN PGP SIGNED MESSAGE----- I got my SCSI tape drive and I installed a SCSI card I had lying around unfortunatly it didn't work :( I THINK the problem may be the controller... I get the messages: aha152x: processing commandline: ok aha152x: BIOS test: passed, detected 1 controller(s) aha152x0: vital data: PORTBASE=0x140, IRQ=9, SCSI ID=7, reconnect=enabled, parity=enabled, synchronous=disabled, delay=100, extended translation=disabled aha152x: trying software interrupt, lost. aha152x: IRQ 9 possibly wrong. Please verify. - --- I have tried IRQ 11 with the same effect...then it is... scsi0 : Adaptec 152x SCSI driver; $Revision: 1.18 $ scsi : 1 host. scsi : aborting command due to timeout : pid 0, scsi0, channel 0, id 0, lun 0 Test Unit Ready 00 00 00 00 00 - --- repeated for id 0 - 6 The SCSI card is from a ZIP SCSI drive (I got it for free from omeone who already had a SCSI card and installed a ZIP) It calls itself (written on the board) an Adaptec AVA-1502 the Tape drive apears to be (jumpers) SCSI ID 4, Parity on, Termination power on Any ideas? should I just forget it asnd buy a new adapter? I recompiled my kernel...turned on SCSI supoert and all of the Adaptec Drivers ...I am running Kernel 2.0.29 (on a hamm system but I doubt that matters) I read the SCSI-HOWTO...but it was of no help :( - -Steve
-----BEGIN PGP SIGNATURE----- Version: 2.6.3a Charset: noconv iQCVAwUBNUfVwnxvn0zebBV9AQGVBAQAhe8UovDSlOKNS6ZPVWw+Ux4EHcRqfJm8 qeGY7+dzJmQM8eHdW+In0kGwpKxVbzmefIJT0tSXsXT1tQHJzKlwl9SzEWcGwFzV ZMI6xA4Zj3AfcUskCNkPNWXfOxyw8ouFxBKOaVyePaGjwc7sk+Fboks+e5ivLhSX ObyL+LUidvo= =ri2i -----END PGP SIGNATURE----- -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]