I had problems with a similar setup (HP660C i.s.o. 890C). Nothing worked until I used magicfilterconfig to create the printer while the Zip was disconnected. I can now print, but have not yet tried if the Zip still works.
J.T. Wenting [EMAIL PROTECTED] www.geocities.com/CapeCanaveral/Hangar/9203 -----Original Message----- From: Christopher S. Swingley [mailto:[EMAIL PROTECTED] Sent: Saturday, December 19, 1998 8:23 PM To: debian-user@lists.debian.org Subject: lp and Debian 2.0 I recently switched my P75 from RedHat 5.1 (the upgrade to 5.2 killed a variety of things) to Official Debian 2.0 R1. I have a HP Deskjet 890C and a Parallel port zip drive plugged in series into the first parallel port. When I set it up originally, I made lp as a module, but when the system boots up it says that there is no device. I haven't gotten around to upgrading things to print, but before I get everything the way I want it, I want to make sure that making lp a module is a good idea. Should I start over? Do I need to pass some sort of parameters to the module via conf.modules? I know it's at 0x378, and I suspect it's irq=7. Thank you very much! You'll save me a lot of trouble later! CSS ------------------------------------ Christopher S. Swingley Department of Biology and Wildlife 213 Irving, x6677 University of Alaska Fairbanks [EMAIL PROTECTED] mercury.bio.uaf.edu/~cswingle.grad ------------------------------------ What you don't know won't help you much either. -- D. Bennett -- Unsubscribe? mail -s unsubscribe [EMAIL PROTECTED] < /dev/null
