Hi, Brandon Sorry I didn't see your message sooner. What I ended up doing is reverting the slink setserial back to the hamm one, and that took care of the problem. I think I'll leave well enough alone, but will save your message for a future attempt. Thanks John B
Brandon Mitchell wrote: > On Sat, 13 Feb 1999, John Bagdanoff wrote: > > > So I don't get the SETSERIAL not found anymore on bootup, but I still > > have to reset the irq to 3 before I reconnect to my isp before every > > session. > > > > I thought at first this change of behavior was due to installing slink > > from my hamm partition, but I also upgraded most of my hamm to slink > > packages at about the same time. What might I have changed to make > > /dev/ttS2 to revert back to irq 4 all the time? I plan to pull out my > > modem and change the jumper setting, but before I do that, I'd like to > > understand why this is happening. > > This has happened to me. Just add "serial" to /etc/modules. If you > don't, serial is autoloaded whenever you need it, but with the default > values. After a while, it is unloaded again, unless you have this line in > your /etc/modules. > > HTH, > Brandon > > +--- ---+ > | Brandon Mitchell [EMAIL PROTECTED] http://bmitch.nws.net/ ICQ 30631197 | > | Throughout history, UNIX systems have regulary been broken into, beaten, | > | brutalized, corrupted, commandeered, compromised, and illegally fscked. | > | -- UNIX System Administration Handbook |

