Hi all, I installed a 2.2.12 kernel and the hedridck patch for udma66; I had: append="mem=127M ide2=0x1e8,0x3ee,11"
in /etc/lilo.conf, but I still have problems; detection is well done BUT not for the good drive: PIIX4: IDE controller on PCI bus 00 dev 39 PIIX4: not 100% native mode: will probe irqs later ide0: BM-DMA at 0xf000-0xf007, BIOS settings: hda:DMA, hdb:pio ide1: BM-DMA at 0xf008-0xf00f, BIOS settings: hdc:DMA, hdd:pio HPT366: onboard version of chipset, pin1=1 pin2=2 PCI: HPT366: Fixing interrupt 11 pin 2 to ZERO HPT366: IDE controller on PCI bus 00 dev 98 HPT366: not 100% native mode: will probe irqs later ide3: BM-DMA at 0xbc00-0xbc07, BIOS settings: hdg:DMA, hdh:pio hda: Maxtor 91728D8, ATA DISK drive hdc: Maxtor 91080D5, ATA DISK drive hdg: IBM-DJNA-351520, ATA DISK drive ide0 at 0x1f0-0x1f7,0x3f6 on irq 14 ide1 at 0x170-0x177,0x376 on irq 15 ide3 at 0xb400-0xb407,0xb802 on irq 11 hda: Maxtor 91728D8, 16479MB w/512kB Cache, CHS=2232/240/63, UDMA(33) hdc: Maxtor 91080D5, 10300MB w/512kB Cache, CHS=20928/16/63, UDMA(33) hdg: IBM-DJNA-351520, 14664MB w/430kB Cache, CHS=29795/16/63, UDMA(66) Floppy drive(s): fd0 is 1.44M Why does the 3rd HD's on /dev/hdg, instead of /dev/hde????? and why does the speed (hdparm -t ..) still the same than under udma33? (and I'm sure that udma66 is Ok on this drive, through the dos utility). So, at this point, I must say: "AAAAAArrrrrrggHHHHH @@^|[{^#!!," Thanks in advance, JY -- Jean-Yves F. Barbier <[EMAIL PROTECTED]> [FORTRAN] will persist for some time -- probably for at least the next decade. -- T. Cheatham