Hi there, I configured demand dialing with diald on my machine. Now my modem dials every five minutes without reason. I increased logging but could not find a hint why. Does anyone know how to find the event that wants a connection ?
Another question: When I run "route" my modem dials, but the command itself hangs. After a while (the second or third dial) my routing table looks like this: Kernel IP routing table Destination Gateway Genmask Flags Metric Ref Use Iface 194.1.1.1 * 255.255.255.255 UH 1 0 0 sl0 194.1.1.0 * 255.255.255.0 U 0 0 0 sl0 localnet * 255.255.255.0 U 0 0 0 eth0 default * 0.0.0.0 U 1 0 0 sl0 default * 0.0.0.0 U 0 0 0 ppp0 After that route works fine. The ifconfig output is the following: lo Link encap:Local Loopback inet addr:127.0.0.1 Mask:255.0.0.0 UP LOOPBACK RUNNING MTU:3924 Metric:1 RX packets:751 errors:0 dropped:0 overruns:0 frame:0 TX packets:751 errors:0 dropped:0 overruns:0 carrier:0 Collisions:0 eth0 Link encap:Ethernet HWaddr 52:54:05:DE:DB:4E inet addr:17.10.10.1 Bcast:17.10.10.255 Mask:255.255.255.0 UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 RX packets:0 errors:0 dropped:0 overruns:0 frame:0 TX packets:73 errors:0 dropped:0 overruns:0 carrier:0 Collisions:0 Interrupt:12 Base address:0xd800 sl0 Link encap:Serial Line IP inet addr:192.168.0.1 P-t-P:194.1.1.1 Mask:255.255.255.0 UP POINTOPOINT RUNNING NOARP MULTICAST MTU:1500 Metric:1 RX packets:0 errors:0 dropped:0 overruns:0 frame:0 TX packets:3099 errors:0 dropped:0 overruns:0 carrier:0 Collisions:0 ppp0 Link encap:Point-to-Point Protocol inet addr:212.184.131.140 P-t-P:193.158.137.77 Mask:255.255.255.255 UP POINTOPOINT RUNNING NOARP MULTICAST MTU:1500 Metric:1 RX packets:9 errors:0 dropped:0 overruns:0 frame:0 TX packets:13 errors:0 dropped:0 overruns:0 carrier:0 Collisions:0 Maybe these two questions are one. Thanks in advance, Klaus.