G0DModE <[EMAIL PROTECTED]> wrote: >After unpacking the XFree 4.0 soft, I wanted to configure it, so I run >"XFree86 -configure" command and the output was: "Segmentation fault". I >tried to install over and over again, but always output was the same.
Where did you get that command from? :) The XFree86 executable in 4.0 doesn't have a -configure option. Try editing /etc/X11/XF86Config (its location may depend on how you installed XFree86). Or, if you're trying to build from source, read INSTALL.TXT. All the details should be in the very comprehensive documentation. -- Colin Watson [EMAIL PROTECTED]