try commenting out everything in /etc/hosts.deny

and putting:

ALL : [EMAIL PROTECTED]

in /etc/hosts.allow

unix/linux seems to not to like to work in an enviornment where there is
no
DNS resolution, or more specifically name resolution in general
(i imagine there isn't in your case), if you want everything
to work perfectly i suggest you configure BIND with a dummy domain and
set your machines up to use it.(my dummy domain is ".aphro" and i have
machine names like internal-gate.aphro and desktop.aphro)

putting each of the machines in /etc/hostts may help too.

nate


Matthias Schulz wrote:
> 
> Hi all,
> 
> I'm still out of luck with a ethernet-connection between 2 computers.
> Here are the facts: debian 2.2 Kernel, 2.2.18, Linksys ethernetcards
> (one PCI, one PCMCIA) crossover cable
> 
> I can ping each other just fine.
> Same machines can telnet each other or nfs-mount directories when I use the
> plip-connection I want to get rid of. (eth down and plip up instead)
> 
> Telnet over eth just waits and times out.
> Same with mount -t nfs.
> route says:
> 
> Kernel IP routing table
> Destination     Gateway         Genmask         Flags Metric Ref    Use Iface
> 192.168.0.0     *               255.255.255.0   U     0      0        0 eth0
> ~>
> 
> ifconfig says:
> 
> eth0      Link encap:Ethernet  HWaddr 39:48:39:48:39:48
>           inet addr:192.168.0.3  Bcast:192.168.0.255  Mask:255.255.255.0
>           UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
>           RX packets:49 errors:0 dropped:0 overruns:0 frame:0
>           TX packets:24 errors:0 dropped:0 overruns:0 carrier:0
>           collisions:0 txqueuelen:100
>           Interrupt:11 Base address:0x9000
> 
> lo        Link encap:Local Loopback
>           inet addr:127.0.0.1  Mask:255.0.0.0
>           UP LOOPBACK RUNNING  MTU:3924  Metric:1
>           RX packets:28 errors:0 dropped:0 overruns:0 frame:0
>           TX packets:28 errors:0 dropped:0 overruns:0 carrier:0
>           collisions:0 txqueuelen:0
> 
> ~>
> 
> Can anyone point me, where to start looking?
> What is in a eth-connection involved and not in a plip?
> 
> Matth
> 
> --
> To UNSUBSCRIBE, email to [EMAIL PROTECTED]
> with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]

-- 
:::
ICQ: 75132336
http://www.aphroland.org/
http://www.linuxpowered.net/
[EMAIL PROTECTED]

Reply via email to