Hello everyone. My soundcard is a soundblaster CT3600. I can't get it to work. I am getting the following error when I try to load modules to use it
as follows:
spoke:/proc# modprobe sb io=0x220 irq=10 dma=1 dma16=5 mpu_io=0x330
Soundblaster audio driver Copyright (C) by Hannu Savolainen 1993-1996
SB 4.13 detected OK (220)
sb: Interrupt test on IRQ10 failed - Probable IRQ conflict
It does the exact same thing when I use different unused irq's.
Do these errors have something to do with the fact that there is a ide
controller on the card? I haven't seen any evidence of this. How do
I get my sound card working?
Thanks,
Mark Y
The /proc info for the above example is as follows:
Script started on Sat Feb 22 03:55:15 2003
spoke:~# cat
/proc/interrupts
CPU0 0: 174178 XT-PIC timer 1: 3495 XT-PIC keyboard 2: 0 XT-PIC cascade 5: 1 XT-PIC eth0 6: 25 XT-PIC floppy 8: 3 XT-PIC rtc 10: 0 XT-PIC soundblaster 11: 51 XT-PIC eth1 12: 3667 XT-PIC PS/2 Mouse 13: 1 XT-PIC fpu 14: 217968 XT-PIC ide0 15: 211 XT-PIC ide1 NMI: 0 spoke:~# cat /proc/dma 1: SoundBlaster8 2: floppy 4: cascade 5: SoundBlaster16 spoke:~# cat /proc/ioports 0000-001f : dma1 0020-003f : pic1 0040-005f : timer 0060-006f : keyboard 0070-007f : rtc 0080-008f : dma page reg 00a0-00bf : pic2 00c0-00df : dma2 00f0-00ff : fpu 0170-0177 : ide1 01f0-01f7 : ide0 0210-021f : 3c509 0220-022f : soundblaster 02f8-02ff : serial(set) 0330-0333 : MPU-401 UART 0376-0376 : ide1 03c0-03df : vga+ 03f0-03f5 : floppy 03f6-03f6 : ide0 03f7-03f7 : floppy DIR 03f8-03ff : serial(set) 6100-611f : eth1 9000-9007 : ide0 9008-900f : ide1 spoke:~# exit exit Script done on Sat Feb 22 03:55:41 2003
The manufactures info about the card is as follows:
Sound Blaster 32 is a 16-bit ISA audio board. This Plug and Play card comes equiped with an IDE CD-ROM interface and an EMU8000 AWE Synthesizer chip. It provides options to upgrade with a SIMM RAM upgrade module General Hardware Settings
Connectors
|