hi ya markus... you need to find that file... whatever it is called...
you need to find the kernel that supports your scsi controller... since you have /dev/hda... its 10x simpler to boot linux off of hda and redirect it to /dev/sda for its root fs... etc... have fun alvin On Fri, 27 Jul 2001, Markus Hansen wrote: > hi Alvin Oga wrote: > > > hi markus > > > > On Thu, Jul 26, 2001 at 12:21:14PM +0200, Markus Hansen wrote: > > > > > > the lilo and the old lilofile (which worked pretty good) are attachements > > > now. > > > maybe i forgetz an important scsi thing to set on in the kernel? > > > or maybe it was the wrong scsi driver, i dont know. > > > NCR 53c875 (rev 38) is my scsi chip on a pci card. > > > > you need initrd in your lilo config ... > > -- see hilighted entry below > > ( find that file in /boot or where you/it installed it... > > > > fix it...than run lilo... and try booting again.. > > > > since you have /dev/hda4... you can amke things 10x easier by > > installing lilo into /dev/hda4 and tell it to boot /dev/sda... > > > > c ya > > alvin > > > > > > ==== > > ==== initrd=/boot/initrd.gz > > ==== > > i changed this in the lilo.conf but it sayed fatal, no such file or > direktory..., > i dont know. > but thank you anyway. > markus > > > -- > To UNSUBSCRIBE, email to [EMAIL PROTECTED] > with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED] >
