May 9, at 18:26, tony mollica sent through the Star Gate: >Hello. I have a mixed network of Linux (Debian) and windows >machines in the arrangement below. > _______ ______ ______ > | | | | | | >--->|router |----| Linux|----|switch|---(192.168.x.x network) > T1 |_______| |______| |______| > | > eth1 eth0 > IP Masq Machine > >Real IP addresses on the router side with the >192.168.x.x on the switch side. I need to put >a another box on the router side but still >have the internal LAN clients access this >computer from the inside. The new computer >is required to be windows, and there will be >only windows clients accessing it.
How you configure it will depend on what you need to use it for, and if you have a single dynamic IP address (which is assigned to the router) or a static subnet from your ISP. Most likely you have a dynamic address for your router. In that case, the WAN side of the router gets that address, the LAN side is most likely assigned something in the 10.0.0.x range. You can have the router do this, or you can assign the IP addresses yourself - 10.0.0.1 to the LAN side of the router, 10.0.0.2 to eth0 on the Linux box, and 10.0.0.3 to the new Windows box. Then, in Linuxconf, set up your routes to other hosts to show that to get to the new Windows box routing has to go through the 10.0.0.x subnet. Glen -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]