Hi! Not a bttv guru, but I used to use it (but nowadays it crashes my system, so not using it at the moment) You wrote: > I have compiled my kernel 2.4.18 with bttv support and have the following > /etc/modutils/actions: > > post-install bttv > /sbin/modprobe "-k" tuner > options bttv pll=1 radio=1 card=54 > options tuner type=5 > > But when I run scantv it say that the tuner type not set. > What do I wrong? I can't say for sure, but: In my setup from Debian/potato, modutils had those details in /etc/modutils/video, and did
pre-install bttv modprobe -k tuner Note the main difference (apart from syntax, filename, etc) is that it is installing the "tuner" module *before* it installs bttv. My system also doesn't give the options, but it detects them correctly. Perhaps those options are needed on your machine, you know your system better than me (and again, I'm not a bttv guru). Note that if you do change the setup to use pre-install, you should not have it use "post-install" as well, or that would make your machine try to load the tuner module twice, and it'll get upset. AFAIK, it makes no difference whether the lines are in /etc/modutils/actions or /etc/modutils/video, but you should know that changes to those files are only updated into /etc/modules.conf when you run update-modules (in case you didn't know). Hope this might be of some help. > -- > have a lot of imbecility! Er, thank you! :) Tomble -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]