I just recenctly purchased a SIIG Fast SCSI Pro (PCI) card. It claims it has Linux support, in the manual and on SIIG's website. Apparently either Advansys or Initio chipsets are used in these cards. Trying to install the kernel module for either of these SCSI chipsets has been unsuccessful.
Is there any particular paramter I should be entering along with the installation of the module? So far any parameters seem to result in an error. Is it possible that the plain vanilla kernel (2.4.17-K6II) may not actually be set up with either of these relevant modules linked into the kernel, therefore requiring me to do a kernel configure & compile? Any help or suggestions would be much appreciated. --------------------------------------- Arlen Carlson <[EMAIL PROTECTED]> Avoid gunfire in the bathroom tonight. This message was sent by XFmail (Linux) -o) /\\ _\_v The penguins are coming... the penguins are coming... ---------------------------------------- -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]