Hi, I posted first to sci.electronics.design, but it seems to be quite noisy. So trying my luck here.
I am currently experimenting with geda and ngspice to simulate basic circuits (for a Circuits Analysis course) and I am only starting to learn how to draw and simulate circuits. I drew a basic circuit in geda and exported it as netlist and got: ####################################################### $> gnetlist -v -g spice-sdb sch_1.sch -o sch_1.net ... (followed by lots of output) ... $> cat sch_1.net * gnetlist -v -g spice-sdb -o sch_1.net sch_1.sch ********************************************************* * Spice file generated by gnetlist * * spice-sdb version 10.9.2004 by SDB -- * * provides advanced spice netlisting capability. * * Documentation at http://www.brorson.com/gEDA/SPICE/ * ********************************************************* V1 2 3 10V R2 1 3 50K R1 2 1 100K .END ####################################################### I was wondering: 1. How can I specify within geda which nodes I want monitored during a simulation? Or do I specify them on ngspice command line, or in the output .net file? I am guessing that I can run a dc simulation and then plot various parameters? 2. How do I export the schematic so that I can include it in a LaTeX file (as PS file perhaps)? I tried exporting it as PNG but I get the whole big 'sheet' with my tiny circuit in the middle. 2b. How do I change the size of the 'sheet' or paper so that it is just big enough to accomodate my little circuits? thanks, ->HS -- Please remove the underscores ( the '_' symbols) from my email address to obtain the correct one. Apologies, but the fudging is to remove spam. -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]