I have the driver but cannot access the driver. The setup utility for the NIC gives me:
3c5x9setup.c:v1.00 6/19/2000 Donald Becker ([EMAIL PROTECTED]) http://www.scyld.com/diag/index.html No interrupt sources are pending. 3c5x9 found at 0x300. Indication enable is 0000, interrupt enable is 0000. EEPROM contents: Model number 3c509 version 5, base I/O 0x300, IRQ 10, 10baseT port. 3Com Node Address 00:50:DA:7E:30:2A (used as a unique ID only). OEM Station address 00:50:DA:7E:30:2A (used as the ethernet address). Manufacture date (MM/DD/YY) 11/11/99, division 6, product WK. Options: half duplex, enable linkbeat. The computed checksum matches the stored checksum of 7e03. The enables don't look right, could that be my problem? Regards, Dave. -----Original Message----- From: Ralph Katz <[EMAIL PROTECTED]> To: debian-user@lists.debian.org <debian-user@lists.debian.org> Date: December 19, 2005 11:57 AM Subject: Re: NIC PnP >On 12/18/2005 08:00 PM, Dave Whelan wrote: >> I can't get my 3c509 working for aliant dsl, does anyone know how I can check >> whether PnP is enabled on this NIC? >> Regards, >> Dave Whelan. > >Dave, > >I have that card working fine on a sarge box with kernel 2.4.27. From >the syslog: > >> Dec 19 10:05:57 localhost kernel: isapnp: Scanning for PnP cards... >> Dec 19 10:05:57 localhost kernel: isapnp: Card '3Com 3C509B EtherLink III' >> Dec 19 10:05:57 localhost kernel: isapnp: 1 Plug & Play card detected total >> Dec 19 10:05:57 localhost kernel: eth0: 3c5x9 at 0x220, 10baseT port, address 0 >> 0 10 4b 15 c4 ed, IRQ 5. >> Dec 19 10:05:57 localhost kernel: 3c509.c:1.19 16Oct2002 [EMAIL PROTECTED] >> Dec 19 10:05:57 localhost kernel: http://www.scyld.com/network/3c509.html > >You should already have the driver: > >$ locate 3c509 >/lib/modules/2.4.27-2-586tsc/kernel/drivers/net/3c509.o > >I do have 3c509 listed in /etc/modules. > >Regards, >Ralph > > >-- >To UNSUBSCRIBE, email to [EMAIL PROTECTED] >with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED] > -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]