I dont have USB 1.1 in my micro. Or exists configuration what i dont made.
On 5/29/06, Brad Sawatzky <[EMAIL PROTECTED]> wrote:
On Sun, 28 May 2006, Edson Marco Ferrari Junior wrote:
> Hi all!
>
> Im try connect a webcam Genius in Debian Sarge.
>
> I install the module spca52xxx and quickcam, but when connect the
> webcam in USB (2.0) in dmesg returns this message:
>
> usb 2-2: new full speed USB device using uhci_hcd and address 6
> usb 2-2: device not accepting address 6, error -71
[ ... ]
I had similar problems with my Creative WebCam NX Pro 2. After much
googling I found the following suggestion worked. Try plugging the camera
into a USB _1.x_ hub (or try bypassing the hub completely). Either
workaround solved the problem for me.
My camera won't initialize correctly if it's plugged into any of my USB 2
hubs (or into an add-on NEC-chipset USB2 pci card for that matter). It
seems this is a semi-common issue with webcams (not just the spca52xxx
driver). I don't know why USB transactions with a webcam would be so
touchy, but a USB hard drive runs fine a full capacity through the same USB
port...
-- Brad
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED]
with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
--
/*
* Edson Marco Ferrari Junior
* [EMAIL PROTECTED]
* http://www.itasoa.com.br (no dia que funcionar eu aviso)
*/
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED]
with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]