On lør, desember 9, 2006 00:46, Sturla Holm Hansen wrote: > Roberto C. Sanchez skrev: >> On Fri, Dec 08, 2006 at 09:15:56PM +0100, Sturla Holm Hansen wrote: >> >>> Hi list. >>> I'm running Xen under Etch and running an instance of Etch under Xen, >>> the >>> host is showing two cpu's but the guest does not... >>> Is smp not supported in the xen-package in Etch or am I doing something >>> wrong? >>> >>> >> >> Did you assigne the guest to more than one CPU in your configuration? >> Is the guest running an SMP kernel? >> >> Regards, >> >> -Roberto >> > Hmmm, I just used the standard scripts with Etch, thanx a lot though, I > had overlooked the fact that I had to specify the number of cpu's in the > config. > Again, thanx for the tip :) > > Sturla
On to another problem though: I was having trouble booting the domu's the second time, Device 2049 (vbd) could not be connected, and I found a tip about increasing the number of loop-devices, so I added "modprobe loop max_devices=64" in /etc/init.d/xend and went on to the next problem: The first domu starts like a charm, so does the next for a couple of seconds before I get a kernel panic about something not syncing (I only have a couple of seconds to read it before the blasted thing reboots) I noticed that the 64 loop devices turns up in /dev/, not in /dev/loop/ (where there's still a 0) don't know if it's supposed to be that way though... Does anyone have a clue about this, and if not can tell med the correct way of increasing the number of loop-devices? Thanx Sturla -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]