When upgrading from sarge to etch I get this error several times. The upgrade
continues (apparently normally) but I
would like to know why I get this and if I can fix it.
perl: warning: Setting locale failed.
perl: warning: Please check that your locale settings:
LANGUAGE = "en_US:en_GB:en",
LC_ALL = (unset),
LANG = "en_US"
are supported and installed on your system.
perl: warning: Falling back to the standard locale ("C").
I have used locale and it shows
sarge-plain:~# locale
LANG=en_US
LANGUAGE=en_US:en_GB:en
LC_CTYPE="en_US"
LC_NUMERIC="en_US"
LC_TIME="en_US"
LC_COLLATE="en_US"
LC_MONETARY="en_US"
LC_MESSAGES="en_US"
LC_PAPER="en_US"
LC_NAME="en_US"
LC_ADDRESS="en_US"
LC_TELEPHONE="en_US"
LC_MEASUREMENT="en_US"
LC_IDENTIFICATION="en_US"
LC_ALL=
But nothing in the man page says anything about how LC_ALL gets set. Only that
it is 'all of the above'
How can I fix this?
Thanks
Tony
