Joe Hart wrote:
-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1
steef wrote:
[snip]
[EMAIL PROTECTED]:~$ sudo ifconfig -a
eth0 Link encap:UNSPEC HWaddr
00-11-D8-00-00-B0-E9-2F-00-00-00-00-00-00-00-00
BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)
eth1 Link encap:Ethernet HWaddr 00:17:31:AA:03:D8
BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)
Interrupt:225 Base address:0xa000
eth2 Link encap:Ethernet HWaddr 00:80:5A:60:08:E7
BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)
Interrupt:50 Base address:0xce00
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:38 errors:0 dropped:0 overruns:0 frame:0
TX packets:38 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:2636 (2.5 KiB) TX bytes:2636 (2.5 KiB)
sit0 Link encap:IPv6-in-IPv4
NOARP MTU:1480 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)
and:[EMAIL PROTECTED]:~$ dmesg | grep RTL
eth1: RealTek RTL8139 at 0xce00, 00:80:5a:60:08:e7, IRQ 50
eth1: Identified 8139 chip type 'RTL-8100B/8139D'
The above is saying you don't have ip addresses assigned to ether card,
which is why you have no internet. You should modify
/etc/network/interfaces to tell your cards to either use dhcp or give it
a static address.
man interfaces should give you all the information you need on how to
configure it.
Joe
- --
Registerd Linux user #443289 at http://counter.li.org/
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.4.6 (GNU/Linux)
Comment: Using GnuPG with Mozilla - http://enigmail.mozdev.org
iD8DBQFGI5IuiXBCVWpc5J4RAlc9AJ923pWEUSS8S+V4X12SqWqcADNA4QCgmfur
v8wqdyedNQKy3D67cFRUlHk=
=6D2r
-----END PGP SIGNATURE-----
thanks joe:
and that is exactly what i did. [the same way i configured
/network/interfaces for a wireless card long ago, a method i forgot till
yesterday-evening] something like:
auto eth2
iface eth2 inet dhcp
so: now i have two good working methods to get the ethernetcards going.
thank you all again.
regards,
steef
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED]
with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]