Default User([EMAIL PROTECTED]) is reported to have said: > On Sun, 2007-04-29 at 11:26 -0400, Wayne Topa wrote: > > Default User([EMAIL PROTECTED]) is reported to have said: > > > On Sat, 2007-04-28 at 22:36 -0400, Wayne Topa wrote: > > > > > > <--<snip>--> > > > > > > To find out which chipset your dongles use, try Googleing with > > > > " linux WG111". You should have the chipset in the 1st or 2nd page. > > > > > > > > > > > > Take a look at <http://madwifi.org> . Look for the Compatibility > > > > page. It shows all of the Atheros cards that work with the madwifi > > > > drivers. I have had very good results with the Netgear WG511U V2 > > > > PCMCIA cards. Very easy to setup and operate in a lot of different > > > > modes. > > > > <--<snip>-->
> > > > > > So far, two wireless adapters have been mentioned as working with Etch, > (assembly required): > And the assembly is really difficult! m-a a-i madwifi > Netgear WG511U V2 pcmcia card > Netgear WG511T pcmcia card > > Is anyone out there using any other currently available wireless > adapters with Etch? I guess you don't have the time to check that out on google either. Bye -- Man is the best computer we can put aboard a spacecraft ... and the only one that can be mass produced with unskilled labor. -- Wernher von Braun _______________________________________________________ -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]