On Sat, 2007-06-09 at 16:23 +0200, Florian Kulzer wrote: > On Fri, Jun 08, 2007 at 19:47:52 -0300, Marcelo Chiapparini wrote: > > On Fri, 2007-06-08 at 23:01 +0200, Florian Kulzer wrote: > > > On Fri, Jun 08, 2007 at 14:53:11 -0300, Marcelo Chiapparini wrote: > > > > Hello, > > > > > > > > I have done a fresh install of etch. When i try to view a video with > > > > totem, nothing is shown, the totem screen is black, but sound is ok. I > > > > can listen the sound but nothjing appears in totem screen. This happens > > > > with video files in mpg, mov or even with a dvd film (after installing > > > > libdvdcss2 (1.2.9-0.0)) > > > > > > > > Any help will be very welcome > > > > Just to remember, I have audio in totem, video is absent. The funny > > thing is that I can see clips at youtube with iceweasel... > > You can easily encounter situations in which, due to incomplete support > of codecs, the audio works but the video does not. The fact that > flashplayer can display video output suggests to me that your problem is > due to the codecs used in the other files. > > [...] > [...] > > > 01:00.0 VGA compatible controller: ATI Technologies Inc Radeon R200 QM > > [Radeon 9100] > > [...] > > > (EE) Unable to find a valid framebuffer device > > (EE) RADEON(0): Failed to open framebuffer device, consult warnings and/or > > errors above for possible reasons > > That might cause problems if the video player tries to use the > framebuffer device for playback. Unfortunately I know neither totem nor > ATI video cards well enough to comment any further on that.
I ran dpkg-reconfigure xserver-xorg and set the framebuffer option to NO. Now the output of egrep '^\((EE|WW)\)' /var/log/Xorg.0.log doesn't contain any error message. But totem continues with its black screen... > [ snip: Your XVideo setup looks OK to me; supported image formats are: > RGBA, RGBT, RGB2, YUY2, UYVY, YV12, I420 ] > > At the moment I think you are missing some video codecs. Check which > totem package you have installed by running > > dpkg -l totem\* | grep ^ii I have totem-xine installed > If you use totem-xine make sure that you have libxine1-ffmpeg installed. this library doesn't exist... even in debian-multimedia.org > You can add Christian Marillat's debian-multimedia repository to your > /etc/apt/sources.list and install the packages gstreamer0.10-ffmpeg-full > and w32codecs to get support for most of the common non-free codecs. > (w32codecs is only available for the i386 architecture.) Further > instructions are available on http://www.debian-multimedia.org. I installed w32codec and totem continues to refuse to show any video output with *.wmv clips... About a month ago, I installed etch in a sony-vaio laptop. Totem ran fine out of the box, without any codec installed by me... is the totem-xine version, the same as in the desktop with problems. The laptop has a ATI Mobility Radeon 9200 video card, so, runs the same driver from x.org as the desktop... I will continue to look for a solution... may be installing another program Thank you very much for your kind help with the best regards Marcelo -- Marcelo Chiapparini [EMAIL PROTECTED] -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]