The stable release of Etch has recently been installed on an old Abit BE6 II motherboard. The previous system run on this board was a 2.4 Sarge.
Whenever, Etch is booted, the boot stops at several points, saying CTRL-D is needede to continue the boot. This has not happened on the Sarge system. Any reasons for the change in boot procedure ? ____________________________________________________________________________________ Luggage? GPS? Comic books? Check out fitting gifts for grads at Yahoo! Search http://search.yahoo.com/search?fr=oni_on_mail&p=graduation+gifts&cs=bz -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]