Mike Ely wrote:
Hi there,
I'm trying to update from the Debian-supplied stock kernel to 2.6.25.2 on
Etch (for GFS2 purposes), and, on my VMWare instance, the new kernel seems
always to hang at "Waiting for root filesystem."
So as I understand it, you run Etch on VMware and compile (with
make-kpkg?) 2.6.25.2 (2.6.25.3 is stable). What .config do you use?
Then on VMware you boot 2.6.25.2 and run into trouble?
I've tried passing different options to make-kpkg, but the result is always
the same. Kernel, modules, initrd all build successfully, but no joy. Boot
times out waiting for the root filesystem, and eventually dumps me into an
emergency shell. Here's the relevant dmesg output from a successful boot
into 2.6.18-5-686:
SCSI subsystem initialized
Fusion MPT base driver 3.04.01
Copyright (c) 1999-2005 LSI Logic Corporation
Fusion MPT SPI Host driver 3.04.01
mptbase: Initiating ioc0 bringup
ioc0: 53C1030: Capabilities={Initiator}
scsi0 : ioc0: LSI53C1030, FwRev=00000000h, Ports=1, MaxQ=128, IRQ=169
Vendor: VMware, Model: VMware Virtual S Rev: 1.0
Type: Direct-Access ANSI SCSI revision: 02
target0:0:0: Beginning Domain Validation
target0:0:0: Domain Validation skipping write tests
target0:0:0: Ending Domain Validation
target0:0:0: FAST-160 WIDE SCSI 320.0 MB/s DT IU RDSTRM RTI WRFLOW PCOMP
(6.25 ns, offset 127)
Obviously, I can't paste the failed dmesg here, but basically what it does
is start the Fusion driver, and load ioc0 but not scsi0.
Anyone seen similar? What am I missing on my kernel build?
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED]
with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]