On Sun, Nov 09, 2008 at 09:05:33 +0000, Virgo Pärna wrote: [...]
> Here is the log: > > virsik:~# tail -fn0 /var/log/syslog [ snip: camera recognized, hal reacts normally, sd driver loaded; everything looks fine until... ] > Nov 9 10:54:18 virsik kernel: [ 4016.216143] usb 4-3: reset high speed USB > device using ehci_hcd and address 2 > Nov 9 10:54:33 virsik kernel: [ 4031.328145] usb 4-3: device descriptor > read/64, error -110 > Nov 9 10:54:48 virsik kernel: [ 4046.544146] usb 4-3: device descriptor > read/64, error -110 > Nov 9 10:54:48 virsik kernel: [ 4046.760149] usb 4-3: reset high speed USB > device using ehci_hcd and address 2 > Nov 9 10:55:03 virsik kernel: [ 4061.872212] usb 4-3: device descriptor > read/64, error -110 > Nov 9 10:55:19 virsik kernel: [ 4077.088139] usb 4-3: device descriptor > read/64, error -110 > Nov 9 10:55:19 virsik kernel: [ 4077.304136] usb 4-3: reset high speed USB > device using ehci_hcd and address 2 > Nov 9 10:55:29 virsik kernel: [ 4087.712157] usb 4-3: device not accepting > address 2, error -110 > Nov 9 10:55:29 virsik kernel: [ 4087.824141] usb 4-3: reset high speed USB > device using ehci_hcd and address 2 > Nov 9 10:55:40 virsik kernel: [ 4098.232143] usb 4-3: device not accepting > address 2, error -110 > Nov 9 10:55:40 virsik kernel: [ 4098.232201] usb 4-3: USB disconnect, > address 2 > Nov 9 10:55:40 virsik kernel: [ 4098.232542] sd 0:0:0:0: Device offlined - > not ready after error recovery Try modprobe -r ehci_hcd and connect the camera again. It seems that this module can cause problems with certain controllers, devices, ports or cables. For more information, see here: https://bugs.edge.launchpad.net/ubuntu/+source/linux-source-2.6.20/+bug/88746 http://www.linux-usb.org/FAQ.html#ts6 You could also try if the 2.6.27 kernel improves the situation. (What you report in your other mail indicates that WinXP can operate the device at normal USB 2.0 speeds, so it would be annoying if Linux restricted you to USB 1.1 speeds.) -- Regards, | http://users.icfo.es/Florian.Kulzer Florian | -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
