Thank Thierry Chatelet very much!
I have just installed airo net 350 wireless card
but can't enter monitor mode with command:
airmon-ng start rausb0
usage: airmon-ng <start|stop> <interface> [channel]
Interface Chipset Driver
eth4 Unknown Unknown (MONITOR MODE NOT SUPPORTED)
I change rausb0 to eth4 or wifi0, it doesn't help
here's a list by iwconfig
eth4 IEEE 802.11-DS ESSID:"tsunami"
Mode:Managed Frequency:2.412 GHz Access Point: Invalid
Bit Rate:11 Mb/s Tx-Power=20 dBm Sensitivity=0/65535
Retry limit:16 RTS thr:off Fragment thr:off
Encryption key:off
Power Management:off
Link Quality=0/100 Signal level=-113 dBm Noise level=-98 dBm
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
wifi0 IEEE 802.11-DS ESSID:"tsunami"
Mode:Managed Frequency:2.412 GHz Access Point: Invalid
Bit Rate:11 Mb/s Tx-Power=20 dBm Sensitivity=0/65535
Retry limit:16 RTS thr:off Fragment thr:off
Encryption key:off
Power Management:off
Link Quality=0/100 Signal level=-113 dBm Noise level=-98 dBm
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
--
To UNSUBSCRIBE, email to [email protected]
with a subject of "unsubscribe". Trouble? Contact [email protected]
Archive:
http://lists.debian.org/[email protected]
