On Sat, 13 Nov 2010 22:23:09 +0700, Sthu Deus wrote: > Thank You for Your time and answer, Camaleón: > >> JFYI (from my notebook): >> >> >> 9 Power_On_Hours 0x0032 049 049 000 Old_age Always >> - 20456 193 Load_Cycle_Count 0x0032 074 074 000 >> Old_age Always - 261161 194 Temperature_Celsius >> 0x0022 100 100 000 Old_age Always - 37 (Lifetime >> Min/Max 21/52) > > From here > > http://www.linux-archive.org/debian-laptop/230272- load_cycle_count-600000-bad.html > > if I have learned the truth, spinning up/down is not shown by > Load_Cycle_Count parameter - but by Start_Stop_Count - in which case I > have not to worry, for it stands the same while running.
Well... in fact that SMART value (load_cycle_count) is what you think: *** http://en.wikipedia.org/wiki/S.M.A.R.T. 193, C1, Load Cycle Count, Load/Unload Cycle Count (Fujitsu), Lower Count of load/unload cycles into head landing zone position.[14] The typical lifetime rating for laptop (2.5-in) hard drives is 300,000 to 600,000 load cycles.[15] Some laptop drives are programmed to unload the heads whenever there has not been any activity for about five seconds. [16] Many Linux installations write to the file system a few times a minute in the background.[17] As a result, there may be 100 or more load cycles per hour, and the load cycle rating may be exceeded in less than a year.[18] 4 04 Start/Stop Count A tally of spindle start/stop cycles. The spindle turns on, and hence the count is increased, both when the hard disk is turned on after having before been turned entirely off (disconnected from power source) and when the hard disk returns from having previously been put to sleep mode.[11] *** Good, bad...? Who knows. Nowadays every hard disk manufacturer applies different strategies within the hard disk firmware for power savings. Note that "start/stop count" parameter does not have a "best rating" value (nor lower/higher are better, is just an "informative" field). SMART test has to be interpreted in whole (there are values that are more important than others) but I would not care much if there is no other sign indicating that something wrong is goin to happen. > But it is bad that it loads the head all the time. - Though I do not > know if it worth (I think it does as my computer is on sure surface) - > to tune it so that it will be flying all the time, or it is unwise? I would contact your hard disk manufacturer and ask about this value (if you provide them the full SMART test results, better). They will tell you if there is is something to worry about or if this is just the normal behaviour. Greetings, -- Camaleón -- To UNSUBSCRIBE, email to debian-user-requ...@lists.debian.org with a subject of "unsubscribe". Trouble? Contact listmas...@lists.debian.org Archive: http://lists.debian.org/pan.2010.11.13.16.50...@gmail.com