Since I don't do this often, what may be very easy is confusing me..... I have switched from DSL (static IP) to cable internet (5 static IPs). I have a sort of network diagram (in a format that I hope can be easily viewed) available at neidorff.com . Below the line there is a link that says "Network Diagram". Some things are not quite right.
Under the DSL setup (old) the router provided me with a translated set of addresses, so that I could use the 192.168.2.* range to connections to the router. With cable, I have 5 static IPs, but the cable "modem" only provides ports for the static IPs. I changed the configuration of the NIC that connects from the server to the cable modem to match a static IP. I can't get PCs on the local LAN (192.168.1.x) to connect to the net using the cable provider's nameservers. If I use the nameservers of my old provider (which are still active for me, for now) they can connect to the net. Why is this? How do I correct it? Here is the routing table $route -n Kernel IP routing table Destination Gateway Genmask Flags Metric Ref Use Iface 108.58.151.192 0.0.0.0 255.255.255.248 U 0 0 0 eth0 192.168.1.0 0.0.0.0 255.255.255.0 U 0 0 0 eth1 169.254.0.0 0.0.0.0 255.255.0.0 U 0 0 0 eth1 0.0.0.0 108.58.151.193 0.0.0.0 UG 0 0 0 eth0 Thanks for any help, Mark -- To UNSUBSCRIBE, email to debian-user-requ...@lists.debian.org with a subject of "unsubscribe". Trouble? Contact listmas...@lists.debian.org Archive: http://lists.debian.org/201101291354.50604.m...@neidorff.com