Hi folks,
I've had Debian installed on a PPC iMac for a long time now, and I've
now also picked up a used Intel iMac (from about 2006 - processor is
32-bit). I've downloaded and burned a netinst CD for squeeze, but the
installation seems remarkably obscure. I've found a few articles, and
done a few things, but I'm having no joy. (PowerPC was easy!!!)
I've installed EFI to control which partition to boot off.
I've got the disk repartitioned OK, I think:
/dev/sda1 MBR
/dev/sda2 / (for Debian) (bootable)
/dev/sda3 Mac OSX
/dev/sda4 swap
I've now repeatedly gone through the installation, and I make sure the
bootable flag is "on" on sda2.
Everything runs normally, then when it gets to install GRUB, I set it to
install on sda2 (I think from what I read that the MBR is actually
unused on an iMac.) Everything appears to go OK. But then when I
reboot, and use EFI to select the Debian partition, I get a GRUB message
telling me "no bootable device".
I've also tried to select Lilo, during the installation, but it gives me
a message that an error occurred without saying what.
There's a Wiki article about Intel Macs, but it talks about custom
kernels and I don't want to go there. I don't want a Windows partition,
just Mac and Linux. I'm getting nowhere -- I'd be grateful for any help!!
Cheers, Mike.
--
---------------------------------------------------------------
Mike Hore mike_h...@aapt.net.au
---------------------------------------------------------------
--
To UNSUBSCRIBE, email to debian-user-requ...@lists.debian.org
with a subject of "unsubscribe". Trouble? Contact listmas...@lists.debian.org
Archive: http://lists.debian.org/4df35c2f.6000...@aapt.net.au
