Hi, I just installed wheeezy 64bit (kernel 3.2.0.4) and the fans (CPU fan and the two fans powered by the MB) are running at full speed. it's a asus p8z68-m pro MB,
Heres the output of sensors: acpitz-virtual-0 Adapter: Virtual device temp1: +27.8°C (crit = +99.0°C) temp2: +29.8°C (crit = +99.0°C) coretemp-isa-0000 Adapter: ISA adapter Physical id 0: +33.0°C (high = +80.0°C, crit = +98.0°C) Core 0: +33.0°C (high = +80.0°C, crit = +98.0°C) Core 1: +33.0°C (high = +80.0°C, crit = +98.0°C) Core 2: +33.0°C (high = +80.0°C, crit = +98.0°C) Core 3: +33.0°C (high = +80.0°C, crit = +98.0°C) Here is the output from sensors-detect: ======================= Now follows a summary of the probes I have just done. Just press ENTER to continue: Driver `w83627ehf': * ISA bus, address 0x290 Chip `Nuvoton NCT6776F Super IO Sensors' (confidence: 9) Driver `coretemp': * Chip `Intel digital thermal sensor' (confidence: 9) To load everything that is needed, add this to /etc/modules: #----cut here---- # Chip drivers coretemp w83627ehf #----cut here---- =================================================== Does acpi-cpufreq need to be added to /etc/moduels? only the below two modules were added coretemp w83627ehf # modproble w83627ehf returns the following error ERROR: could not insert 'w83627ehf': Device or resource busy After doing some research, and reading http://www.lm-sensors.org/wiki/FAQ/Chapter3#Mysensorshavestoppedworkinginkernel3.33.2.23.0.18 I replaced w83627ehf with asus_atk0110 in /etc/modules still no use, the fans keep running at maximum. Also fancontrol does not run because there is no /etc/fancontrol and when I run pwmconfig, it says: There are no pwm-capable sensor modules installed. Does that mean I need to write /etc/fancontrol file manually? Kind regards, Yudi