error fetching interface information: device not found
Running modconf brings up a menu driven app which asks me, "please select the category of modules". There are no categories shown, only, "exit finished. return to previous menu". Clicking "ok" takes me back to the command line.
help?
Allasso
On Wednesday, October 15, 2003, at 10:52 AM, fullmer wrote:
From: ernobe <[EMAIL PROTECTED]> Date: Wednesday 15 October 2003 10:48:49 To: [EMAIL PROTECTED] no references
Subject: Re: no network access on new install From: ernobe <[EMAIL PROTECTED]> Date: Tue, 14 Oct 2003 20:39:08 -0600 Newsgroup: linux.debian.user
Manually running ifup eth0 says that eth0 is already configured
How so?
I am sure it is obvious by now that I know almost nothing about linux, (I'll refrain from using the "n" word), but I do need help.
How can I determine if the kernel is recognizing my interfaces?
If you've booted into the Debian partition, the startup procedure indicates
whether or not it is recognizing your eth0 card. For it to do so you need
a module for it installed in your kernel. These are in /lib/modules/....
So my advice is for you to startup the other operating system and then
check the startup process to see what ethernet card is being detected. You
can then use this information to determine the module you'll need. If you
find that it boots into your display and doesn't give you a chance to see
the startup process, you need to edit your /etc/inittab file so that you
edit out the line that sets the initial runlevel to 2 ( just comment it out
-- this is in Debian, I don't know about RedHat ) Then when it boots you
can go back to check the process by using shift+PageUp. Once you've
determined what card you have, boot back into Debian with your machine
disconnected from the net ( just unplug it from the modem ) Then, supposing
you have the standard program modconf, run it and check under net modules
to see if you recognize any name similar to the one you've seen in the boot
of the other operating system. Click on it, and it will ask if you want to
install it, say yes, and then you should be connected. To test it enter
/sbin/ifconfig eth0 at an X-term prompt, and see if it detects your card.
If it does and you know your IP and netmask you can enter them like this
/sbin/ifconfig eth0 (your IP) netmask (your netmask) Your gateway is like
this: route add default gw (your gateway) And the /etc/resolv.conf file
has your name server, like this
search
nameserver (your nameserver)
A sample /etc/network/interfaces file can be found in the manpage for
interfaces, copy it with your info, then reboot.
-- http://www.costarricense.cr/pagina/ernobe
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
