On 02/02/14 09:14, Csanyi Pal wrote: > Scott Ferguson <scott.ferguson.debian.u...@gmail.com> writes: > >> On 01/02/14 21:57, Csanyi Pal wrote: >>> Scott Ferguson <scott.ferguson.debian.u...@gmail.com> writes: >>> >>>> On 31/01/14 04:53, Csanyi Pal wrote: >>>>> Hi, >>>>> >>>>> I just bought an USB dongle nano Netis WF-2120 adapter. >>>>> I want to set it up on my headless Debian Wheezy server as a Wireless >>>>> Access Point. >>>>> >> <snipped> >>>>> >>>>> However, I can't find the installed driver, and I don't know how can I >>>>> load it as a kernel module? >>>>> >>>> >>>> >>>> Had you read this wiki page about that chipset? >>>> https://wiki.debian.org/rtl819x >>> >>> Yes, I had. There I found that that my USB Wifi adapter is supported: >>> >>> when I plug in the WiFi usb adapter, lsusb shows the following: >>> Bus 001 Device 004: ID 0bda:8176 Realtek Semiconductor Corp. RTL8188CUS >>> 802.11n WLAN Adapter >>> >>> and on the webpage https://wiki.debian.org/rtl819x there is this davice >>> listed: >>> >>> USB: 0BDA:8176 Realtek Semiconductor Corp. RTL8188CUS 802.11n WLAN >>> Adapter >>> >>> On the web page: https://wiki.debian.org/rtl819x there I found the >>> following information: >>> >>> rtl8192cu (supported devices) >>> >>> Supports USB devices based on the RTL8188CUS and RTL8192CU chips. >>> >>> Introduced in Linux 2.6.39, enabled at >>> linux-2.6 2.6.39~rc7-1~experimental.1. >>> >>> So now what should I do to get this USB Wifi adapter works? > >> Did you install the matching headers? > > I did install the linux-headers-2.6-powerpc. > >> Do you get a match on the chipset series when greping through the >> likely modules after piping through string? > > When I run 'make menuconfig' in the kernel source directory, I found the > Realtek RTL8192CU/RTL8188CU USB Wireless Network Adapter > module > > in the > > Linux/powerpc 2.6.39.4-4 Kernel Configuration / \ > Device Drivers / Network device support / Wireless LAN > > In menuconfig I saved the setup in to .config file. > > But when I run after 'make menuconfig' the 'make' command, I get error > message: > > arch/powerpc/kernel/align.c: In function ‘fix_alignment’: > arch/powerpc/kernel/align.c:704:33: error: variable ‘instruction’ set > but not used [-Werror=unused-but-set-variable] > cc1: all warnings being treated as errors > make[1]: *** [arch/powerpc/kernel/align.o] Error 1 > make: *** [arch/powerpc/kernel] Error 2 > > What could be the problem here? >
Sorry (again). But I don't have clue. I can tell you how to suppress the warning (--disable-werror):- http://gcc.gnu.org/onlinedocs/gcc/Warning-Options.html but not how to fix the problem that generates it. Kind regards -- To UNSUBSCRIBE, email to debian-user-requ...@lists.debian.org with a subject of "unsubscribe". Trouble? Contact listmas...@lists.debian.org Archive: http://lists.debian.org/52ed8b92.6020...@gmail.com
