Gene Heskett wrote on 06/09/16 17:59: > On Thursday 09 June 2016 05:39:08 Jörg-Volker Peetz wrote: > >> Yeah, you got a lot of stuff here ;-) >> >> The repositories all got the same priority 500 besides the >> wheezy-backports i386 target release which is set to priority 100. >> These priorities are normally set in /etc/apt/preferences. What is the >> contents of this file on your system? > > I don't have a file there, I have a preferences.d, and its empty. > >> The easiest to try for your specific request is to list also the >> dependencies explicitly in the apt-get command: >> >> apt-get -s -t wheezy-backports install freecad freecad-doc >> qt4-dev-tools libsoqt4-20 python-pivy > > Reading package lists... Done > Building dependency tree > Reading state information... Done > Suggested packages: > qt4-doc-html > Recommended packages: > qt4-designer qt4-doc > The following NEW packages will be installed: > freecad freecad-doc qt4-dev-tools > The following packages will be upgraded: > libsoqt4-20 python-pivy > 2 upgraded, 3 newly installed, 0 to remove and 6 not upgraded. > Inst libsoqt4-20 [1.5.0-2] (1.6.0~e8310f-1~bpo70+1 Debian > Backports:/wheezy-backports [i386]) > Inst qt4-dev-tools (4:4.8.6+git64-g5dc8b2b+dfsg-3~bpo70+1 Debian > Backports:/wheezy-backports [i386]) > Inst python-pivy [0.5.0~v609hg-1] (0.5.0~v609hg-3~bpo70+1 Debian > Backports:/wheezy-backports [i386]) > Inst freecad (0.14.3702+dfsg-3~bpo70+1 Debian Backports:/wheezy-backports > [i386]) > Inst freecad-doc (0.14.3702+dfsg-3~bpo70+1 Debian Backports:/wheezy-backports > [all]) > Conf libsoqt4-20 (1.6.0~e8310f-1~bpo70+1 Debian Backports:/wheezy-backports > [i386]) > Conf qt4-dev-tools (4:4.8.6+git64-g5dc8b2b+dfsg-3~bpo70+1 Debian > Backports:/wheezy-backports [i386]) > Conf python-pivy (0.5.0~v609hg-3~bpo70+1 Debian Backports:/wheezy-backports > [i386]) > Conf freecad (0.14.3702+dfsg-3~bpo70+1 Debian Backports:/wheezy-backports > [i386]) > Conf freecad-doc (0.14.3702+dfsg-3~bpo70+1 Debian Backports:/wheezy-backports > [all]) > > Which is as far as I got since the needed updated version of python-pivy > isn't available even from sloppy, and neither is the newer version of > libsoqt4-20 (1.6.0~e8310f-1~bpo70+1 > <snip> Ah, the above command line has the "-s" switch for "simulate". Did you really try to perform the installation?
apt-get -t wheezy-backports install freecad freecad-doc qt4-dev-tools libsoqt4-20 python-pivy (in one command line). Regards, jvp.
