On 2020-07-19 13:00, Gene Heskett wrote:
Greetings all;
Very disapointed in the results from the openscad to Cura to ender 3
pro
results. Forstarters, no support for gcodes g2/g3 so everything has to
be cobbled up with short straight lines.
So I installed slic3r. but all I get is the help screen which is
several
pages long. But one of the options is to start it with -gui as option.
That also fails, looking for Wx.
Full error report:
gene@coyote:~/Downloads/stl.stf/files$ slic3r --gui
Can't locate Wx.pm in @INC (you may need to install the Wx module)
(@INC
contains: /usr/bin/lib /usr/lib/slic3r/ /etc/perl
/usr/local/lib/x86_64-linux-gnu/perl/5.24.1
/usr/local/share/perl/5.24.1 /usr/lib/x86_64-linux-gnu/perl5/5.24
/usr/share/perl5 /usr/lib/x86_64-linux-gnu/perl/5.24
/usr/share/perl/5.24 /usr/local/lib/site_perl
/usr/lib/x86_64-linux-gnu/perl-base)
at /usr/lib/slic3r/Slic3r/GUI/AboutDialog.pm line 6.
BEGIN failed--compilation aborted
at /usr/lib/slic3r/Slic3r/GUI/AboutDialog.pm line 6.
Compilation failed in require at /usr/lib/slic3r/Slic3r/GUI.pm line 8.
BEGIN failed--compilation aborted at /usr/lib/slic3r/Slic3r/GUI.pm line
8.
Compilation failed in require at (eval 77) line 1.
This is stretch, uptodate. What can I do? Backports doesn't seem to be
enabled.
Cheers, Gene Heskett
excuse me for not knowing what I'm talking about but if is a Perl module
you are after cannot use cpan ?
mick
--
Key ID 4BFEBB31
