This isn't a Debian-specific topic, but it seems my ISP doesn't carry comp(?).os.linux.setup anymore so...
I've just installed a USB card in my old computer. It's a Belkin 5-port card. I get a couple of errors in this messages in dmesg. usbdevfs: remount parameter error ****** RE: the above error I have the following line in /etc/fstab, as suggested in libgphoto2-2? none /proc/bus/usb usbdevfs devuid=0,devgid=106,devmode=0660 0 0 but 'mount' gives this: none on /proc/bus/usb type usbdevfs (rw,devuid=0,devgid=106,devmode=0660) ********* PCI: Assigned IRQ 12 for device 00:09.0 usb-ohci.c: USB OHCI at membase 0xc5836000, IRQ 12 usb-ohci.c: usb-00:09.0, NEC Corporation USB usb.c: new USB bus registered, assigned bus number 1 hub.c: USB hub found hub.c: 3 ports detected *********** Above seems OK PCI: Enabling device 00:09.1 (0000 -> 0002) PCI: No IRQ known for interrupt pin B of device 00:09.1. usb-ohci.c: found OHCI device with no IRQ assigned. check BIOS settings! ** ?????????? # What is this? I disabled ttyS0 (on the mainboard), which freed up # IRQ 4. It then assigned IRQ 4 to 00.09.0 but left IRQ 12 free, still # didn't assign anyting to 00.09.1, so it's not for lack of IRQ's, # apparently. As for "check BIOS settings", I don't think there's # anyting to be done in the computer's BIOS. ehci_hcd 00:09.2: NEC Corporation USB 2.0 ehci_hcd 00:09.2: irq 11, pci mem c583d000 usb.c: new USB bus registered, assigned bus number 2 ehci_hcd 00:09.2: USB 2.0 enabled, EHCI 1.00, driver 2003-Jun-19/2.4 hub.c: USB hub found hub.c: 5 ports detected uhci.c: USB Universal Host Controller Interface driver v1.1 usb-uhci.c: $Revision: 1.275 $ time 01:22:43 Jan 3 2004 usb-uhci.c: High bandwidth mode enabled usb-uhci.c: v1.275:USB Universal Host Controller Interface driver ########### # I installed a USB mouse and it seems to work fine: hub.c: new USB device 00:09.0-3, assigned address 2 input: USB HID v1.10 Mouse [Microsoft Microsoft 3-Button Mouse with IntelliEye(TM)] on usb1:2.0 mice: PS/2 mouse device common for all mice ########################## So... can anyone tell me what's going on? Also, in Windows98, it shows a conflict for one of the controllers, too. I just cannot figure out what is the problem. Could it be a faulty card? I notice that in the boot sequence above, if that matters, that the IRQ error occurs before IRQ 11 is assigned to the other controller. -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]