Hi, I've been using the i810fb in kernel 2.6.x with no problems on sarge. Below is the append line I used in Lilo; video=i810fb:vram:2,xres:1024,yres:768,bpp:16,hsync1:30,hsync2:55,vsync1 :50,vsync2:85,accel,mtrr (note: The hsync and vsync are not the actual values. I'm not at my system and can't remember what they are.)
Last night I switched from using lilo to grub. everything went ok. I added the above to my grub config and rebooted. The console is fine except for one thing. I get what appears to be a block cursor in the middle of the screen. When I log in, the cursor stays in the middle of the screen until I hit enter, it then jumps to the bottom left. From then on it sort of follows what I type but not quite, it remains somewhat out of sync with where the cursor should actually be. I tried using 'hwcur' on the above but this didn't do anything. I'm using the same parameters that I used with lilo, yet I never had this issue. Apart from switching back to lilo, is there anything I can try to resolve this? TIA Paddy -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]