Michel D?nzer wrote: > On Mon, 2005-10-24 at 22:33 -0400, Wakko Warner wrote: > > I recently bought a flat panel monitor (Samsung SyncMaster 204T). My card > > has a DVI, VGA, and S-Video output. Res is 1600x1200. Vanilla kernel > > 2.6.12 with intel-agp and radeon drivers loaded. Systemboard is a > > Supermicro X5DA8 with 2 xeon 2.6ghz processors. Monitor is attached via DVI > > cable. I have not tested any other cables or monitors since those flat > > panel things are just too expensive =) My previous monitor was a Princeton > > EO900 (ran at 1400x1050 and had no problems). The system has been turned > > off since the flat panel was installed as the card didn't activate the > > digital interface until it was reset. > > > > When doing some operations (Moving very large windows, 3d graphics like > > Quake 3 or xscreensaver-gl's gears with -planetary -fps -delay 0) causes the > > monitor to blank out. Quake3 mostly causes the screen to blank and never > > show anything. Running gears causes it to blank as well, however the > > display comes back, but goes out again until it's closed. > > > > This was with XFree86 4.3 (One of the versions before Sarge stabilized). I > > decided to install Xorg from SID instead. The blanking wasn't as bad but > > was > > still bad enough that gears was unviewable. Quake3 still was blank. I > > noticed there was a newer Xorg in /debian/pool/main/x/xorg-x11 so I > > installed it (version 6.8.99.901.dfsg.1-1) which is doing much better and > > Quake3 is actually usable, but the screen does still blank occasionally. > > Does > > Option "DisplayPriority" "HIGH"
No, it does not and it makes 3d a little slower (running gears with this gives me 295fps where as w/o the option I get about 340) I did find out that it only does this using the digital connection. I did not try analog on the DVI connector. -- Lab tests show that use of micro$oft causes cancer in lab animals Got Gas??? -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]