Since the tested null device has no capacity of HW CRC offload,
disable it for the link bonding rssconf test by default. Otherwise,
it will cause test unexpected failure.

Fixes: b219c8c("test: enable HW CRC strip by default")

Signed-off-by: Phil Yang <phil.y...@arm.com>
---
 test/test/test_link_bonding_rssconf.c | 16 ++++------------
 1 file changed, 4 insertions(+), 12 deletions(-)

diff --git a/test/test/test_link_bonding_rssconf.c 
b/test/test/test_link_bonding_rssconf.c
index 6a1a28d..b23e4e8 100644
--- a/test/test/test_link_bonding_rssconf.c
+++ b/test/test/test_link_bonding_rssconf.c
@@ -82,12 +82,8 @@ static struct rte_eth_conf default_pmd_conf = {
        .rxmode = {
                .mq_mode = ETH_MQ_RX_NONE,
                .max_rx_pkt_len = ETHER_MAX_LEN,
-               .split_hdr_size = 0,
-               .header_split   = 0, /**< Header Split disabled */
-               .hw_ip_checksum = 0, /**< IP checksum offload enabled */
-               .hw_vlan_filter = 0, /**< VLAN filtering disabled */
-               .jumbo_frame    = 0, /**< Jumbo Frame Support disabled */
-               .hw_strip_crc   = 1, /**< CRC stripped by hardware */
+               .offloads = 0,
+               .ignore_offload_bitfield = 1,
        },
        .txmode = {
                .mq_mode = ETH_MQ_TX_NONE,
@@ -99,12 +95,8 @@ static struct rte_eth_conf rss_pmd_conf = {
        .rxmode = {
                .mq_mode = ETH_MQ_RX_RSS,
                .max_rx_pkt_len = ETHER_MAX_LEN,
-               .split_hdr_size = 0,
-               .header_split   = 0, /**< Header Split disabled */
-               .hw_ip_checksum = 0, /**< IP checksum offload enabled */
-               .hw_vlan_filter = 0, /**< VLAN filtering disabled */
-               .jumbo_frame    = 0, /**< Jumbo Frame Support disabled */
-               .hw_strip_crc   = 1, /**< CRC stripped by hardware */
+               .offloads = 0,
+               .ignore_offload_bitfield = 1,
        },
        .txmode = {
                .mq_mode = ETH_MQ_TX_NONE,
-- 
2.7.4

Reply via email to