>> -----Original Message----- >> From: dev <[email protected]> On Behalf Of >> [email protected] >> Sent: Wednesday, December 4, 2019 8:14 PM >> To: [email protected]; Marko Kovacevic ><[email protected]>; Ori >> Kam <[email protected]>; Bruce Richardson >> <[email protected]>; Radu Nicolau ><[email protected]>; >> Akhil Goyal <[email protected]>; Tomasz Kantecki >> <[email protected]>; Sunil Kumar Kori ><[email protected]>; >> Pavan Nikhilesh <[email protected]> >> Cc: [email protected] >> Subject: [dpdk-dev] [PATCH v2 04/11] examples/l3fwd: add ethdev >setup >> based on eventdev >> >> From: Sunil Kumar Kori <[email protected]> >> >> Add ethernet port Rx/Tx queue setup for event device which are later >> used for setting up event eth Rx/Tx adapters. >> >> Signed-off-by: Sunil Kumar Kori <[email protected]> >> --- >> examples/l3fwd/l3fwd.h | 10 +++ >> examples/l3fwd/l3fwd_event.c | 129 >> ++++++++++++++++++++++++++++++++++- >> examples/l3fwd/l3fwd_event.h | 2 +- >> examples/l3fwd/main.c | 15 ++-- >> 4 files changed, 144 insertions(+), 12 deletions(-) >> > ><snip> > >> + >> + local_port_conf.rx_adv_conf.rss_conf.rss_hf &= >> + >> dev_info.flow_type_rss_offloads; >> + if (local_port_conf.rx_adv_conf.rss_conf.rss_hf != >> + port_conf- >>rx_adv_conf.rss_conf.rss_hf) { >> + printf("Port %u modified RSS hash function " >> + "based on hardware support," >> + "requested:%#"PRIx64" >> configured:%#"PRIx64"\n", >> + port_id, >> + port_conf->rx_adv_conf.rss_conf.rss_hf, >> + >local_port_conf.rx_adv_conf.rss_conf.rss_hf); >> + } > >We are using 1 queue, but using RSS hash function?
rte_event::flow_id which uniquely identifies a given flow is generated using RSS Hash function on the required fields in the packet. > >> + >> + ret = rte_eth_dev_configure(port_id, 1, 1, >&local_port_conf); >> + if (ret < 0) >> + rte_exit(EXIT_FAILURE, >> + "Cannot configure device: err=%d, >> port=%d\n", >> + ret, port_id); >> + > >We should be using number of RX queues as per the config option >provided in the arguments. >L3fwd is supposed to support multiple queue. Right? The entire premise of using event device is to showcase packet scheduling to cores without the need for splitting packets across multiple queues. Queue config is ignored when event mode is selected. > >Regards, >Nipun > Regards, Pavan.
