From: Rohit Raj <rohit....@nxp.com>

Fixed 10G port negotiation issue with another 10G/non 10G port.

When running testpmd with 10G interfaces on 10BaseT interface
on LS2088ARDB, the ports were showing link as down.

This was identified to be caused by the setting of link as down
during config.
Also, the line rate was not being updated in device link params,
thus having the incorrect link speed in status (as 0).

Fixes: c5acbb5ea20e ("net/dpaa2: support link status event")
Cc: sta...@dpdk.org

Signed-off-by: Rohit Raj <rohit....@nxp.com>
---
 drivers/net/dpaa2/dpaa2_ethdev.c | 4 +---
 1 file changed, 1 insertion(+), 3 deletions(-)

diff --git a/drivers/net/dpaa2/dpaa2_ethdev.c b/drivers/net/dpaa2/dpaa2_ethdev.c
index 2cde55e7cc..4fc550a885 100644
--- a/drivers/net/dpaa2/dpaa2_ethdev.c
+++ b/drivers/net/dpaa2/dpaa2_ethdev.c
@@ -553,9 +553,6 @@ dpaa2_eth_dev_configure(struct rte_eth_dev *dev)
        if (rx_offloads & DEV_RX_OFFLOAD_VLAN_FILTER)
                dpaa2_vlan_offload_set(dev, ETH_VLAN_FILTER_MASK);
 
-       /* update the current status */
-       dpaa2_dev_link_update(dev, 0);
-
        return 0;
 }
 
@@ -1757,6 +1754,7 @@ dpaa2_dev_set_link_up(struct rte_eth_dev *dev)
        /* changing tx burst function to start enqueues */
        dev->tx_pkt_burst = dpaa2_dev_tx;
        dev->data->dev_link.link_status = state.up;
+       dev->data->dev_link.link_speed = state.rate;
 
        if (state.up)
                DPAA2_PMD_INFO("Port %d Link is Up", dev->data->port_id);
-- 
2.17.1

Reply via email to