> -----Original Message----- > From: Huisong Li <[email protected]> > Sent: Tuesday, April 20, 2021 17:01 > To: [email protected] > Cc: Yigit, Ferruh <[email protected]>; Li, Xiaoyun > <[email protected]>; > [email protected]; [email protected] > Subject: [PATCH V3 6/7] app/testpmd: add forwarding config in start port > > Most operations in testpmd that need to update the forwarding streams in > testpmd call fwd_config_setup(). In some scenarios, eg, dev_configure is > called > again, the forwarding streams may not be updated. As a result, the actual > forwarding streams cannot be queried by "show config fwd" cmd.
I don't agree on this. Fwd config should be only changed after the user change something like nb-cores, queue number, eth-peer in non-dcb mode. These are already done in those commands. You should do fwd_config_setup at the end of cmd_config_dcb_parsed(), I agree on this. But doing it in start port seems to do redundant times of fwd_setup. It's not really needed. > > The procedure is as follows: > set nbcore 4 > port stop all > port config 0 dcb vt off 4 pfc on > port start all > show config fwd > > Signed-off-by: Huisong Li <[email protected]> > Signed-off-by: Lijun Ou <[email protected]> > --- > app/test-pmd/testpmd.c | 6 ++++++ > 1 file changed, 6 insertions(+) > > diff --git a/app/test-pmd/testpmd.c b/app/test-pmd/testpmd.c index > abcbdaa..f8052b6 100644 > --- a/app/test-pmd/testpmd.c > +++ b/app/test-pmd/testpmd.c > @@ -2678,6 +2678,12 @@ start_port(portid_t pid) > } > } > } > + /* > + * In some scenarios, eg, dev_configure is called again, the forwarding > + * streams may not be updated. As a result, the actual forwarding > + * streams cannot be queried by "show config fwd" command. > + */ > + fwd_config_setup(); > > printf("Done\n"); > return 0; > -- > 2.7.4
