Hello Keith, I sent the patch as it is described in http://dpdk.org/dev but I got confused and I did not put that it was a patch for Pktgen. I hope it does not make anyone get confused.
Thank you, I?aki Murillo El 21/04/16 a las 16:28, Wiles, Keith escribi?: >> Hello Keith, >> >> I have done a patch to the pktgen, but I not sure how to submit it. I >> would be very grateful if you give me some advice on how to contribute. > Please have a look at the DPDK.org page on development : http://dpdk.org/dev > > You could send me the patch on the current Pktgen and I can review the > changes. > >> Thank you, >> >> I?aki Murillo >> >> El 12/04/16 a las 14:55, Wiles, Keith escribi?: >>>> Hello >>>> >>>> I have been using pktgen for a while and I released that there is no >>>> possibility to set a rate between two whole numbers. >>>> >>>> I looked up the source code and I found out that the rate is stored in >>>> a uint8_t. So, I made a quick-and-dirty change just to check if it is >>>> possible to get a speed between two hole numbers. It seemed to work >>>> properly. >>>> >>>> Is there a reason to use an uint8_t instead of a float, for example? >>> The uint8_t was easier then using floats :-) >>> >>> If you have a patch for this change please send it along and I will look at >>> adding the support. >>> >>>> Thank you, >>>> >>>> I?aki Murillo >>>> >>> Regards, >>> Keith >>> >>> >>> >>> >> > > Regards, > Keith > > > >