Hi Wenzhuo,

<snip>

> > > > If nb_rxq and nb_txq are set to max_rx_queues and max_tx_queues
> > > > respectively, there is a failure when the port is started in
> > > > ixgbe_check_mq_mode() at line
> > > > 1990 in ixgbe_ethdev.c.
> > > > SRIOV is active, nb_rx_q=128 nb_tx_q=128 queue number must be less
> > > > than or equal to 1.
> > > I haven't hit this issue. Would you like to give more details about
> > > how to hit it? I'll check if I miss something.
> >
> > There is a Niantic PF and VF bound to igb_uio. Port 0 is the PF and
> > Port 1 is the VF.
> > ./testpmd -c 3f -l 1-5 -n 4 -- -i
> > testpmd> set corelist 2,3,4,5
> > testpmd> port stop 0  /* PF is 0 */
> > testpmd> port config 0 dcb vt on 4 pfc on port start 0 /* PF is 0 */
> > line 1990   ixgbe_ethdev.c
> > SRIOV is active, nb_rx_q=128 nb_tx_q=128 queue number must be less
> > than or equal to 1.
> > /* Works if nb_rx_q and nb_tx_q set to 1 */
> To my opinion, it's a by-design limitation. After using the DCB configuration
> CLI, the queue number is set to a fix number which is the max number. But
> as you pointed, when SRIOV is active there's another requirement for the
> queue number.
> We need to investigate deeper and find a solution for it. But I think it's
> another story. We need another patch for it.

Line 1997 in testpmd.c
1997    if (dcb_mode == DCB_VT_ENABLED) {
                nb_rxq = rte_port->dev_info.max_rx_queues;
                nb_txq = rte_port->dev_info.max_tx_queues;
        } else {
2001            /*if vt is disabled, use all pf queues */
                if (rte_port->dev_info.vmdq_pool_base == 0) {
                        nb_rxq = rte_port->dev_info.max_rx_queues;
                        nb_txq = rte_port->dev_info.max_tx_queues;
                } else {
                        nb_rxq = (queueid_t)num_tcs;
                        nb_txq = (queueid_t)num_tcs;
                }
        }

The comment at line 2001 implies that when dcb_mode is DCB_VT_ENABLED all pf 
queues should not be used.
When dcb_mode is DCB_VT_ENABLED, setting nb_rxq and nb_txq equal to 1 works 
when the PF (port 0) is started.
When dcb_mode is DCB_VT_ENABLED, setting nb_rxq to max_rx_queues and nb_txq to 
max_tx_queues results in the following failure in ixgbe when the PF (port 0) is 
started.
SRIOV is active, nb_rx_q=128 nb_tx_q=128 queue number must be less than or 
equal to 1.

<snip>

Regards,

Bernard

Reply via email to