The model is:
rte_eal_init
`--> calls rte_eal_bus_probe()
This iterates over all the drivers and devices and matches them. For
matched bus specific device-driver:
`--> bus->probe()
This would be responsible for generic work, equivalent to
rte_eal_pci_probe - specific to the bus. Handles over control
to,
`--> rte_driver->probe()
which works equivalent to rte_eth_dev_pci_probe for alloc-
-ating a ethernet device. This would hand over the control
to,
`--> rte_xxx_driver->probe()
Calls driver specific initialization of the eth_dev
Similar to what eth_dev_init of eth_driver does.
In further changes, eth_driver would be removed.
Signed-off-by: Shreyansh Jain <shreyansh.j...@nxp.com>
---
lib/librte_eal/common/eal_common_bus.c | 50 +++++++++++++++++++++++++++++++++-
1 file changed, 49 insertions(+), 1 deletion(-)
diff --git a/lib/librte_eal/common/eal_common_bus.c
b/lib/librte_eal/common/eal_common_bus.c
index 67b808b..469abac 100644
--- a/lib/librte_eal/common/eal_common_bus.c
+++ b/lib/librte_eal/common/eal_common_bus.c
@@ -195,11 +195,59 @@ rte_eal_bus_scan(void)
return 0;
}
+static int
+perform_probe(struct rte_bus *bus __rte_unused, struct rte_driver *driver,
+ struct rte_device *device)
+{
+ int ret;
+
+ if (!driver->probe) {
+ RTE_LOG(ERR, EAL, "Driver (%s) doesn't support probe.\n",
+ driver->name);
+ /* This is not an error - just a badly implemented PMD */
+ return 0;
+ }
+
+ ret = driver->probe(driver, device);
+ if (ret < 0)
+ /* One of the probes failed */
+ RTE_LOG(ERR, EAL, "Probe failed for (%s).\n", driver->name);
+
+ /* In either case, ret <0 (error), ret > 0 (not supported) and ret = 0
+ * success, return ret
+ */
+ return ret;
+}
+
/* Match driver<->device and call driver->probe() */
int
rte_eal_bus_probe(void)
{
- /* Until driver->probe is available, this is dummy implementation */
+ int ret;
+ struct rte_bus *bus;
+ struct rte_device *device;
+ struct rte_driver *driver;
+
+ /* For each bus registered with EAL */
+ TAILQ_FOREACH(bus, &rte_bus_list, next) {
+ TAILQ_FOREACH(device, &bus->device_list, next) {
+ TAILQ_FOREACH(driver, &bus->driver_list, next) {
+ ret = bus->match(driver, device);
+ if (!ret) {
+ ret = perform_probe(bus, driver,
+ device);
+ if (ret < 0)
+ return ret;
+
+ /* ret == 0 is success; ret >0 implies
+ * driver doesn't support the device.
+ * in either case, continue
+ */
+ }
+ }
+ }
+ }
+
return 0;
}
--
2.7.4
