bnxt_hwrm_port_phy_cfg() was not setting enables appropriately.
This was causing undesired issues with link config.
This patch takes care of that.
Fixes: 7bc8e9a227cc ("net/bnxt: support async link notification")
Signed-off-by: Stephen Hurd <stephen.h...@broadcom.com>
Signed-off-by: Ajit Khaparde <ajit.khapa...@broadcom.com>
--
v1->v2: split the patch into relevant patches based on code review
---
drivers/net/bnxt/bnxt_hwrm.c | 22 +++++++++++++++-------
1 file changed, 15 insertions(+), 7 deletions(-)
diff --git a/drivers/net/bnxt/bnxt_hwrm.c b/drivers/net/bnxt/bnxt_hwrm.c
index 85ef0e3..da078f9 100644
--- a/drivers/net/bnxt/bnxt_hwrm.c
+++ b/drivers/net/bnxt/bnxt_hwrm.c
@@ -628,6 +628,8 @@ static int bnxt_hwrm_port_phy_cfg(struct bnxt *bp, struct
bnxt_link_info *conf)
struct hwrm_port_phy_cfg_input req = {0};
struct hwrm_port_phy_cfg_output *resp = bp->hwrm_cmd_resp_addr;
uint32_t enables = 0;
+ uint32_t link_speed_mask =
+ HWRM_PORT_PHY_CFG_INPUT_ENABLES_AUTO_LINK_SPEED_MASK;
HWRM_PREP(req, PORT_PHY_CFG, -1, resp);
@@ -639,14 +641,20 @@ static int bnxt_hwrm_port_phy_cfg(struct bnxt *bp, struct
bnxt_link_info *conf)
* any auto mode, even "none".
*/
if (!conf->link_speed) {
- req.auto_mode |= conf->auto_mode;
- enables = HWRM_PORT_PHY_CFG_INPUT_ENABLES_AUTO_MODE;
- req.auto_link_speed_mask = conf->auto_link_speed_mask;
- enables |=
- HWRM_PORT_PHY_CFG_INPUT_ENABLES_AUTO_LINK_SPEED_MASK;
- req.auto_link_speed = bp->link_info.auto_link_speed;
- enables |=
+ req.auto_mode = conf->auto_mode;
+ enables |= HWRM_PORT_PHY_CFG_INPUT_ENABLES_AUTO_MODE;
+ if (conf->auto_mode ==
+ HWRM_PORT_PHY_CFG_INPUT_AUTO_MODE_SPEED_MASK) {
+ req.auto_link_speed_mask =
+ conf->auto_link_speed_mask;
+ enables |= link_speed_mask;
+ }
+ if (bp->link_info.auto_link_speed) {
+ req.auto_link_speed =
+ bp->link_info.auto_link_speed;
+ enables |=
HWRM_PORT_PHY_CFG_INPUT_ENABLES_AUTO_LINK_SPEED;
+ }
}
req.auto_duplex = conf->duplex;
enables |= HWRM_PORT_PHY_CFG_INPUT_ENABLES_AUTO_DUPLEX;
--
2.10.1 (Apple Git-78)
